HP Aruba Certified Campus Access Mobility Expert Written HPE7-A07 Dumps in PDF

Free HP HPE7-A07 Real Questions (page: 4)

Refer to the CLI output below:



What statement about the output above is correct?

  1. The port-access role was configured with gateway-role visitor
  2. The secondary tunnel endpoint IP is 10.10-10.151.
  3. The client authenticated using dot1x.
  4. The UBT zone was configured to use a user-defined VRF

Answer(s): B

Explanation:

The CLI output indicates a tunnel creation process, where "SW hw tun created" refers to the switch hardware tunnel being created. The line mentioning "BYP-10.10.10.101 -> SW hw tun created to 10.10.10.151 tunnel 15." implies that a tunnel was established to the secondary tunnel endpoint with the IP address 10.10.10.151. This is a common configuration for User-Based Tunneling (UBT) setups where traffic is tunneled to a specific endpoint.



Which statement is true given the following CLI output from a CX 6300?

  1. The underlay loopback addresses are in the 172 21 11 x range.
  2. There are two anycast addresses m me overlay fabric.
  3. Duplicate MAC addresses were detected in the overlay fabric
  4. There are three active client overlay VLANs in the overlay fabric

Answer(s): A

Explanation:

The CLI output displays EVPN routes and their corresponding next hops. The "Route Distinguisher" entries followed by IP addresses in the 172.21.11.x range indicate these are loopback addresses used by the underlay network. The underlay network provides the basic routing and forwarding plane for the overlay network that EVPN is part of. These loopback addresses are crucial for the proper functioning of the EVPN control plane.



DRAG DROP (Drag and Drop is not supported)
Your customer is requesting a 4-ciass LAN queuing model tor QoS. Following best practices, match the PHB/DSCP values to the application types.

  1. See Explanation section for answer.

Answer(s): A

Explanation:

Best Effort and Scavenger = DF (0)
Bulk and Transactional Data = AF21 (18)
Multimedia Streaming = AF31 (26)
Real-Time Interactive = EF (46)



You configured" a bridged mode SSID with WPA3-Enterprise and EAP-TLS security.
When you connect an Active Directory joined client that has valid client certificates. ClearPass shows the following error.



What is needed to resolve this issue?

  1. Enable authorization in your Authentication Method.
  2. Recreate the SSID m tunneled mode.
  3. Modify your ACX-AD authentication source to include the UPN in the search.
  4. Configure ClearPass to trust the client certificate.

Answer(s): C

Explanation:

The error message "User not found" indicates that the authentication source, in this case, Active Directory (AD), is not able to locate the user account based on the current search parameters. This often occurs when the User Principal Name (UPN) that the client is using to authenticate is not included in the search parameters of the AD authentication source within ClearPass. By modifying the AD authentication source to include the UPN in the search, ClearPass will be able to correctly locate the user account and proceed with the authentication using the valid client certificates.



Refer to the exhibit.



Which statement is true?

  1. The client performed passive scanning
  2. The client is using BSS Fast Transition
  3. The client is failing 802.1X authentication
  4. The client used an incorrect passphrase

Answer(s): C

Explanation:

The exhibit shows a series of 802.1X authentication steps with multiple "Deauthentication" frames, which indicate that the client is not successfully completing the authentication process. Since the frames show repeated attempts at authentication followed by deauthentication, this suggests that the client is failing the 802.1X authentication process, which is required for network access in a WPA2/WPA3-Enterprise security environment.



Share your comments for HP HPE7-A07 exam with other users:

J
Jayant
11/2/2023 3:15:00 AM

thanks for az 700 dumps

B
Bipul Mishra
12/14/2023 7:12:00 AM

thank you for this tableau dumps . it will helpfull for tableau certification

H
hello
10/31/2023 12:07:00 PM

good content

M
Matheus
9/3/2023 2:14:00 PM

just testing if the comments are real

Y
yenvti2@gmail.com
8/12/2023 7:56:00 PM

very helpful for exam preparation

M
Miguel
10/5/2023 12:16:00 PM

question 11: https://help.salesforce.com/s/articleview?id=sf.admin_lead_to_patient_setup_overview.htm&type=5

N
Noushin
11/28/2023 4:52:00 PM

i think the answer to question 42 is b not c

S
susan sandivore
8/28/2023 1:00:00 AM

thanks for the dump

A
Aderonke
10/31/2023 12:51:00 AM

fantastic assessments

P
Priscila
7/22/2022 9:59:00 AM

i find the xengine test engine simulator to be more fun than reading from pdf.

S
suresh
12/16/2023 10:54:00 PM

nice document

W
Wali
6/4/2023 10:07:00 PM

thank you for making the questions and answers intractive and selectable.

N
Nawaz
7/18/2023 1:10:00 AM

answers are correct?

D
das
6/23/2023 7:57:00 AM

can i belive this dump

S
Sanjay
10/15/2023 1:34:00 PM

great site to practice for sitecore exam

J
jaya
12/17/2023 8:36:00 AM

good for students

B
Bsmaind
8/20/2023 9:23:00 AM

nice practice dumps

K
kumar
11/15/2023 11:24:00 AM

nokia 4a0-114 dumps

V
Vetri
10/3/2023 12:59:00 AM

great content and wonderful to have the answers with explanation

R
Ranjith
8/21/2023 3:39:00 PM

for question #118, the answer is option c. the screen shot is showing the drop down, but the answer is marked incorrectly please update . thanks for sharing such nice questions.

E
Eduardo Ramírez
12/11/2023 9:55:00 PM

the correct answer for the question 29 is d.

D
Dass
11/2/2023 7:43:00 AM

question no 22: correct answers: bc, 1 per session 1 per page 1 per component always

R
Reddy
12/14/2023 2:42:00 AM

these are pretty useful

D
Daisy Delgado
1/9/2023 1:05:00 PM

awesome

A
Atif
6/13/2023 4:09:00 AM

yes please upload

X
Xunil
6/12/2023 3:04:00 PM

great job whoever put this together, for the greater good! thanks!

L
Lakshmi
10/2/2023 5:26:00 AM

just started to view all questions for the exam

R
rani
1/19/2024 11:52:00 AM

helpful material

G
Greg
11/16/2023 6:59:00 AM

hope for the best

H
hi
10/5/2023 4:00:00 AM

will post exam has finished

V
Vmotu
8/24/2023 11:14:00 AM

really correct and good analyze!

H
hicham
5/30/2023 8:57:00 AM

excellent thanks a lot

S
Suman C
7/7/2023 8:13:00 AM

will post once pass the cka exam

R
Ram
11/3/2023 5:10:00 AM

good content

AI Tutor 👋 I’m here to help!