HP Aruba Certified Campus Access Mobility Expert Written HPE7-A07 Dumps in PDF

Free HP HPE7-A07 Real Questions (page: 3)

Refer to the CLI output below:



What statement about the output above is correct?

  1. The port-access role was configured with gateway-role visitor
  2. The secondary tunnel endpoint IP is 10.10-10.151.
  3. The client authenticated using dot1x.
  4. The UBT zone was configured to use a user-defined VRF

Answer(s): B

Explanation:

The CLI output indicates a tunnel creation process, where "SW hw tun created" refers to the switch hardware tunnel being created. The line mentioning "BYP-10.10.10.101 -> SW hw tun created to 10.10.10.151 tunnel 15." implies that a tunnel was established to the secondary tunnel endpoint with the IP address 10.10.10.151. This is a common configuration for User-Based Tunneling (UBT) setups where traffic is tunneled to a specific endpoint.



Which statement is true given the following CLI output from a CX 6300?

  1. The underlay loopback addresses are in the 172 21 11 x range.
  2. There are two anycast addresses m me overlay fabric.
  3. Duplicate MAC addresses were detected in the overlay fabric
  4. There are three active client overlay VLANs in the overlay fabric

Answer(s): A

Explanation:

The CLI output displays EVPN routes and their corresponding next hops. The "Route Distinguisher" entries followed by IP addresses in the 172.21.11.x range indicate these are loopback addresses used by the underlay network. The underlay network provides the basic routing and forwarding plane for the overlay network that EVPN is part of. These loopback addresses are crucial for the proper functioning of the EVPN control plane.



DRAG DROP (Drag and Drop is not supported)
Your customer is requesting a 4-ciass LAN queuing model tor QoS. Following best practices, match the PHB/DSCP values to the application types.

  1. See Explanation section for answer.

Answer(s): A

Explanation:

Best Effort and Scavenger = DF (0)
Bulk and Transactional Data = AF21 (18)
Multimedia Streaming = AF31 (26)
Real-Time Interactive = EF (46)



You configured" a bridged mode SSID with WPA3-Enterprise and EAP-TLS security.
When you connect an Active Directory joined client that has valid client certificates. ClearPass shows the following error.



What is needed to resolve this issue?

  1. Enable authorization in your Authentication Method.
  2. Recreate the SSID m tunneled mode.
  3. Modify your ACX-AD authentication source to include the UPN in the search.
  4. Configure ClearPass to trust the client certificate.

Answer(s): C

Explanation:

The error message "User not found" indicates that the authentication source, in this case, Active Directory (AD), is not able to locate the user account based on the current search parameters. This often occurs when the User Principal Name (UPN) that the client is using to authenticate is not included in the search parameters of the AD authentication source within ClearPass. By modifying the AD authentication source to include the UPN in the search, ClearPass will be able to correctly locate the user account and proceed with the authentication using the valid client certificates.



Refer to the exhibit.



Which statement is true?

  1. The client performed passive scanning
  2. The client is using BSS Fast Transition
  3. The client is failing 802.1X authentication
  4. The client used an incorrect passphrase

Answer(s): C

Explanation:

The exhibit shows a series of 802.1X authentication steps with multiple "Deauthentication" frames, which indicate that the client is not successfully completing the authentication process. Since the frames show repeated attempts at authentication followed by deauthentication, this suggests that the client is failing the 802.1X authentication process, which is required for network access in a WPA2/WPA3-Enterprise security environment.



Share your comments for HP HPE7-A07 exam with other users:

J
Jude
8/29/2023 1:56:00 PM

why is the answer to "which of the following is required by scrum?" all of the following stated below since most of them are not mandatory? sprint retrospective. members must be stand up at the daily scrum. sprint burndown chart. release planning.

M
Marc blue
9/15/2023 4:11:00 AM

great job. hope this helps out.

A
Anne
9/13/2023 2:33:00 AM

upload please. many thanks!

P
pepe el toro
9/12/2023 7:55:00 PM

this is so interesting

A
Antony
11/28/2023 12:13:00 AM

great material thanks

T
Thembelani
5/30/2023 2:22:00 AM

anyone who wrote this exam recently

P
P
9/16/2023 1:27:00 AM

ok they re good

J
Jorn
7/13/2023 5:05:00 AM

relevant questions

A
AM
6/20/2023 7:54:00 PM

please post

N
Nagendra Pedipina
7/13/2023 2:22:00 AM

q:42 there has to be a image in the question to choose what does it mean from the options

B
BrainDumpee
11/18/2023 1:36:00 PM

looking for cphq dumps, where can i find these for free? please and thank you.

S
sheik
10/14/2023 11:37:00 AM

@aarun , thanks for the information. it would be great help if you share your email

R
Random user
12/11/2023 1:34:00 AM

1z0-1078-23 need this dumps

L
labuschanka
11/16/2023 6:06:00 PM

i gave the microsoft azure az-500 tests and prepared from this site as it has latest mock tests available which helped me evaluate my performance and score 919/1000

M
Marianne
10/22/2023 11:57:00 PM

i cannot see the button to go to the questions

S
sushant
6/28/2023 4:52:00 AM

good questions

A
A\MAM
6/27/2023 5:17:00 PM

q-6 ans-b correct. https://docs.paloaltonetworks.com/pan-os/9-1/pan-os-cli-quick-start/use-the-cli/commit-configuration-changes

U
unanimous
12/15/2023 6:38:00 AM

very nice very nice

A
akminocha
9/28/2023 10:36:00 AM

please help us with 1z0-1107-2 dumps

J
Jefi
9/4/2023 8:15:00 AM

please upload the practice questions

T
Thembelani
5/30/2023 2:45:00 AM

need this dumps

A
Abduraimov
4/19/2023 12:43:00 AM

preparing for this exam is overwhelming. you cannot pass without the help of these exam dumps.

P
Puneeth
10/5/2023 2:06:00 AM

new to this site but i feel it is good

A
Ashok Kumar
1/2/2024 6:53:00 AM

the correct answer to q8 is b. explanation since the mule app has a dependency, it is necessary to include project modules and dependencies to make sure the app will run successfully on the runtime on any other machine. source code of the component that the mule app is dependent of does not need to be included in the exported jar file, because the source code is not being used while executing an app. compiled code is being used instead.

M
Merry
7/30/2023 6:57:00 AM

good questions

V
VoiceofMidnight
12/17/2023 4:07:00 PM

Delayed the exam until December 29th.

U
Umar Ali
8/29/2023 2:59:00 PM

A and D are True

V
vel
8/28/2023 9:17:09 AM

good one with explanation

G
Gurdeep
1/18/2024 4:00:15 PM

This is one of the most useful study guides I have ever used.

AI Tutor 👋 I’m here to help!