Amazon
Avaya
Cisco
CompTIA
CrowdStrike
EC-Council
EXIN
Fortinet
Google
ISC
ISC2
ITIL
Juniper
Microsoft
NVIDIA
Okta
Palo Alto Networks
Salesforce
SAP
ServiceNow
All Vendors

Cisco Certified Network Associate (CCNA) 200-301 Dumps in PDF

Free Cisco 200-301 Real Questions (page: 5)

200-301 PDF — 1395 Questions

Which action is taken by switch port enabled for PoE power classification override?

  1. If a monitored port exceeds the maximum administrative value for power, the port is shutdown and err-disabled.
  2. When a powered device begins drawing power from a PoE switch port, a syslog message is generated.
  3. As power usage on a PoE switch port is checked, data flow to the connected device is temporarily paused.
  4. If a switch determines that a device is using less than the minimum configured power, it assumes the device has failed and disconnects it.

Answer(s): A

Explanation:

PoE monitoring and policing compares the power consumption on ports with the administrative maximum value (either a configured maximum value or the port's default value). If the power consumption on a monitored port exceeds the administrative maximum value, the following actions occur:
- A syslog message is issued.
- The monitored port is shut down and error-disabled.
- The allocated power is freed.


Reference:

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/ios/12-2SX/configuration/guide/book/power_over_ethernet.pdf



What occurs to frames during the process of frame flooding?

  1. Frames are sent to all ports, including those that are assigned to other VLANs.
  2. Frames are sent to every port on the switch that has a matching entry in MAC address table.
  3. Frames are sent to every port on the switch in the same VLAN except from the originating port.
  4. Frames are sent to every port on the switch in the same VLAN.

Answer(s): C



Which function does the range of private IPv4 addresses perform?

  1. allows multiple companies to each use the same addresses without conflicts
  2. provides a direct connection for hosts from outside of the enterprise network
  3. ensures that NAT is not required to reach the Internet with private range addressing
  4. enables secure communications to the Internet for all external hosts

Answer(s): A



Which action must be taken to assign a global unicast IPv6 address on an interface that is derived from the MAC address of that interface?

  1. explicitly assign a link-local address
  2. disable the EUI-64 bit process
  3. enable SLAAC on an interface
  4. configure a stateful DHCPv6 server on the network

Answer(s): C



Several new coverage cells are required to improve the Wi-Fi network of an organization. Which two standard designs are recommended? (Choose two.)

  1. 5GHz provides increased network capacity with up to 23 nonoverlapping channels.
  2. 5GHz channel selection requires an autonomous access point.
  3. Cells that overlap one another are configured to use nonoverlapping channels.
  4. Adjacent cells with overlapping channels use a repeater access point.
  5. For maximum throughput, the WLC is configured to dynamically set adjacent access points to the channel.

Answer(s): A,C



PDF
Viewing page 5 of 281

Share your comments for Cisco 200-301 exam with other users:

A
Anonymous User
4/14/2026 12:31:34 PM

Question 2:
For question 2, the key concept is the Longest Prefix Match. Routers pick the route whose subnet mask is the most specific (largest prefix length) that still matches the destination IP.
From the options:

  • A) 10.10.10.0/28 ? 10.10.10.0–10.10.10.15
  • B) 10.10.13.0/25 ? 10.10.13.0–10.10.13.127
  • C) 10.10.13.144/28 ? 10.10.13.144–10.10.13.159
  • D) 10.10.13.208/29 ? 10.10.13.208–10.10.13.215

The destination Host A’s IP must fall within 10.10.13.208–10.10.13.215 for the /29 to be the best match. Since /29 is the longest prefix among the matching options, Router1 will use 10.10.13.208/29.
Thus, the correct answer is D.

Canada
Y
yenvti2@gmail.com
8/12/2023 7:56:00 PM

very helpful for exam preparation

Anonymous
X
Xunil
6/12/2023 3:04:00 PM

great job whoever put this together, for the greater good! thanks!

Anonymous
X
x-men
5/23/2023 1:02:00 AM

q23, its an array, isnt it? starts with [ and end with ]. its an array of objects, not object.

UNITED STATES
D
Dan
8/10/2023 4:19:00 PM

question 129 is completely wrong.

UNITED STATES
D
Da_costa
8/1/2023 5:28:00 PM

these are free brain dumps i understand, how can one get free pdf

Anonymous
D
Da Costa
8/27/2023 11:43:00 AM

question 128 the answer should be static not auto

Anonymous
C
CiscoStudent
11/15/2023 5:29:00 AM

in question 272 the right answer states that an autonomous acces point is "configured and managed by the wlc" but this is not what i have learned in my ccna course. is this a mistake? i understand that lightweight aps are managed by wlc while autonomous work as standalones on the wlan.

Anonymous
B
Berihun Desalegn Wonde
7/13/2023 11:00:00 AM

all questions are more important

Anonymous
R
RAWI
7/9/2023 4:54:00 AM

is this dump still valid? today is 9-july-2023

SWEDEN
B
Berihun
7/13/2023 7:29:00 AM

all questions are so important and covers all ccna modules

Anonymous
N
Nico
4/23/2023 11:41:00 PM

my 3rd purcahse from this site. these exam dumps are helpful. very helpful.

ITALY
D
Da Costa
8/25/2023 7:30:00 AM

question 423 eigrp uses metric

Anonymous
G
Gurdeep
1/18/2024 4:00:15 PM

This is one of the most useful study guides I have ever used.

CANADA
AI Tutor 👋 I’m here to help!