Palo Alto Networks SD-WAN Engineer SD-WAN-Engineer Dumps in PDF

Free Palo Alto Networks SD-WAN-Engineer Real Questions (page: 8)

Based on the HA topology image below, which two statements describe the end-state when power is removed from the ION 1200-S labeled “Active”, assuming that the ION labeled “Standby” becomes the active ION? (Choose two.)

  1. Both the connection to ISP A and the connection to LTE/5G will be usable.
  2. The VRRP Virtual IP address assigned to any SVIs will be moved to the newly active ION.
  3. The newly active ION will send a gratuitous ARP to the LAN for the IP address of any SVIs.
  4. The connection to ISP A will be usable, but the connection to LTE/5G will not.

Answer(s): B,C

Explanation:

In a branch HA deployment:
-The VRRP Virtual IP addresses assigned to SVIs are moved to the newly active ION, maintaining continuity of traffic routing.
-The newly active ION sends gratuitous ARPs on the LAN to update switches and hosts with the MAC address of the VRRP IPs, ensuring minimal disruption.
Connections to ISP A or LTE/5G depend on whether the interfaces are physically connected to the standby ION and their configuration; in this topology, only the LAN-facing behavior is guaranteed by VRRP and ARP.



During a security audit, an administrator must provide evidence of the routing isolation and controlled leaking between the PCI-Zone and the Mgmt-Zone on a specific ION device.
Which command, when executed on the ION CLI, will output the configuration for all VRF route leak rules?

  1. dump vrf route_leak_rule all
  2. inspect vrf info all
  3. show routing-table vrf-leak
  4. debug vrf leak-database

Answer(s): A

Explanation:

This command displays all configured VRF route-leaking rules on the ION device, including the source VRF, destination VRF, VNIs, and permitted IP prefixes.
It allows the administrator to verify controlled route leaking between the PCI-Zone and Mgmt-Zone while confirming their routing isolation.


Reference:

https://docs.paloaltonetworks.com/prisma-sd-wan/ion-cli-reference/use-cli-commands/dump-comm ands/dump-vrf



A network design mandates segmentation at the routing level and traffic isolation across various services, such as teller cash registers, ATM traffic, guest Wi-Fi, and corporate applications.
Which command can be used to validate and display the Virtual Routing and Forwarding (VRF) route leak rules?

  1. show interface vrf route_leak_rule all
  2. dump vrf route_leak_rule
  3. inspect flow_browser vrf all
  4. inspect vrf route_leak_rule all

Answer(s): D

Explanation:

The command inspect vrf route_leak_rule all in Prisma SD-WAN is used to validate and display VRF route leak rules. This allows administrators to verify which routes are being shared between VRFs, ensuring proper segmentation and traffic isolation across different services such as teller systems, ATMs, guest Wi-Fi, and corporate applications.



In which modes can a Prisma SD-WAN branch be deployed?

  1. Testing, Control, POV
  2. Production, Control, Disabled
  3. Disabled, Analytics, Control
  4. POV, Production, Analytics

Answer(s): D

Explanation:

A Prisma SD-WAN branch can operate in POV (Proof of Value), Production, or Analytics modes.
-POV mode is used for evaluation and testing.
-Production mode enables full SD-WAN functionality for live traffic.
-Analytics mode allows traffic observation without influencing forwarding decisions, useful for assessment or gradual deployment.
-



A network engineer is monitoring a high availability (HA) pair of ION 7000 devices at a regional hub. During a maintenance window, the active device's control link interface is accidentally disabled, interrupting the heartbeat communication between the peers.
Which action does the standby ION device perform?

  1. It transitions to a standby-bypass mode that forwards all traffic to the data center ION for remote processing until the local peer recovers.
  2. It assumes the active role and issues a gratuitous ARP to redirect incoming frames to its own physical or virtual interfaces.
  3. It monitors the primary device's public WAN IP addresses and triggers a failover if those addresses become unreachable.
  4. It enters a dual-active state to load-balance traffic across both circuits until the controller resolves the split-brain condition.

Answer(s): B

Explanation:

In an ION high availability pair, loss of the HA control-link heartbeat causes the standby device to take over the active role when failover conditions are met. It then uses gratuitous ARP to update neighboring devices so traffic is redirected to the newly active ION interfaces.



A new Prisma SD-WAN site is deployed with one internet (ISP-1) and one MPLS circuit (Carrier-B). The public VPNs to the data center ION are up, but the private VPNs over MPLS transport are down.
Which mismatch is the root cause of the issue?

  1. Circuit category between the site and data center
  2. Circuit name between the site and data center
  3. Circuit speed between the site and data center
  4. WAN network between the site and data center

Answer(s): D

Explanation:

Private VPN formation over MPLS depends on matching WAN network definitions between the branch and data center sites. If the MPLS circuits are associated with different WAN networks, Prisma SD-WAN cannot establish the private overlay tunnels across that transport, even though public VPNs over the internet remain operational.



Which IONs can support Branch Gateway?

  1. 3102V, 3200, 1200S, 5200
  2. 1200, 3200, 9200, 7108V
  3. 3104V, 1200S, 5200, 7108V
  4. 9200, 3200, 5200, 7116V

Answer(s): D

Explanation:

Prisma SD-WAN Branch Gateway functionality is supported on higher-capacity ION models that can handle aggregation and gateway services for multiple branch connections. Models such as 9200, 3200, 5200, and 7116V are capable of acting as Branch Gateways, providing routing, security, and SD-WAN overlay termination for branch sites.



When an ION device has been claimed, the cloud-based controller generates and communicates with the device by which method?

  1. Manufacturer Installed Certificate (MIC)
  2. Existing customer public key infrastructure (KPI)
  3. Self-signed certificate
  4. Customer Installed Certificate (CIC)

Answer(s): A

Explanation:

When a Prisma SD-WAN ION device is claimed, the cloud-based controller communicates securely with the device using the Manufacturer Installed Certificate (MIC). The MIC is pre-installed by the manufacturer on the device, enabling secure authentication and encrypted communication with the Prisma SD-WAN cloud controller.



Share your comments for Palo Alto Networks SD-WAN-Engineer exam with other users:

S
Sonia
7/23/2023 4:03:00 PM

very helpfull

B
binEY
10/6/2023 5:15:00 AM

good questions

N
Neha
9/28/2023 1:58:00 PM

its helpful

D
Desmond
1/5/2023 9:11:00 PM

i just took my oracle exam and let me tell you, this exam dumps was a lifesaver! without them, iam not sure i would have passed. the questions were tricky and the answers were obscure, but the exam dumps had everything i needed. i would recommend to anyone looking to pass their oracle exams with flying colors (and a little bit of cheating) lol.

D
Davidson OZ
9/9/2023 6:37:00 PM

22. if you need to make sure that one computer in your hot-spot network can access the internet without hot-spot authentication, which menu allows you to do this? answer is ip binding and not wall garden. wall garden allows specified websites to be accessed with users authentication to the hotspot

3
381
9/2/2023 4:31:00 PM

is question 1 correct?

L
Laurent
10/6/2023 5:09:00 PM

good content

S
Sniper69
5/9/2022 11:04:00 PM

manged to pass the exam with this exam dumps.

D
Deepak
12/27/2023 2:37:00 AM

good questions

D
dba
9/23/2023 3:10:00 AM

can we please have the latest exam questions?

P
Prasad
9/29/2023 7:27:00 AM

please help with jn0-649 latest dumps

G
GTI9982
7/31/2023 10:15:00 PM

please i need this dump. thanks

E
Elton Riva
12/12/2023 8:20:00 PM

i have to take the aws certified developer - associate dva-c02 in the next few weeks and i wanted to know if the questions on your website are the same as the official exam.

B
Berihun Desalegn Wonde
7/13/2023 11:00:00 AM

all questions are more important

G
gr
7/2/2023 7:03:00 AM

ques 4 answer should be c ie automatically recover from failure

R
RS
7/27/2023 7:17:00 AM

very very useful page

B
Blessious Phiri
8/12/2023 11:47:00 AM

the exams are giving me an eye opener

A
AD
10/22/2023 9:08:00 AM

3rd so far, need to cover more

M
Matt
11/18/2023 2:32:00 AM

aligns with the pecd notes

S
Sri
10/15/2023 4:38:00 PM

question 4: b securityadmin is the correct answer. https://docs.snowflake.com/en/user-guide/security-access-control-overview#access-control-framework

H
H.T.M. D
6/25/2023 2:55:00 PM

kindly please share dumps

S
Satish
11/6/2023 4:27:00 AM

it is very useful, thank you

C
Chinna
7/30/2023 8:37:00 AM

need safe rte dumps

1
1234
6/30/2023 3:40:00 AM

can you upload the cis - cpg dumps

D
Did
1/12/2024 3:01:00 AM

q6 = 1. download odt application 2. create a configuration file (xml) 3. setup.exe /download to download the installation files 4. setup.exe /configure to deploy the application

J
John
10/12/2023 12:30:00 PM

great material

D
Dinesh
8/1/2023 2:26:00 PM

could you please upload sap c_arsor_2302 questions? it will be very much helpful.

L
LBert
6/19/2023 10:23:00 AM

vraag 20c: rsa veilig voor symmtrische cryptografie? antwoord c is toch fout. rsa is voor asymmetrische cryptogafie??

G
g
12/22/2023 1:51:00 PM

so far good

M
Milos
8/4/2023 9:33:00 AM

question 31 has obviously wrong answers. tls and ssl are used to encrypt data at transit, not at rest.

D
Diksha
9/25/2023 2:32:00 AM

pls provide dump for 1z0-1080-23 planning exams

H
H
7/17/2023 4:28:00 AM

could you please upload the exam?

A
Anonymous
9/14/2023 4:47:00 AM

please upload this

N
Naveena
1/13/2024 9:55:00 AM

good material

AI Tutor 👋 I’m here to help!