Palo Alto Networks SD-WAN Engineer SD-WAN-Engineer Dumps in PDF

Free Palo Alto Networks SD-WAN-Engineer Real Questions (page: 10)

Based on the HA topology image below, which two statements describe the end-state when power is removed from the ION 1200-S labeled “Active”, assuming that the ION labeled “Standby” becomes the active ION? (Choose two.)

  1. Both the connection to ISP A and the connection to LTE/5G will be usable.
  2. The VRRP Virtual IP address assigned to any SVIs will be moved to the newly active ION.
  3. The newly active ION will send a gratuitous ARP to the LAN for the IP address of any SVIs.
  4. The connection to ISP A will be usable, but the connection to LTE/5G will not.

Answer(s): B,C

Explanation:

In a branch HA deployment:
-The VRRP Virtual IP addresses assigned to SVIs are moved to the newly active ION, maintaining continuity of traffic routing.
-The newly active ION sends gratuitous ARPs on the LAN to update switches and hosts with the MAC address of the VRRP IPs, ensuring minimal disruption.
Connections to ISP A or LTE/5G depend on whether the interfaces are physically connected to the standby ION and their configuration; in this topology, only the LAN-facing behavior is guaranteed by VRRP and ARP.



During a security audit, an administrator must provide evidence of the routing isolation and controlled leaking between the PCI-Zone and the Mgmt-Zone on a specific ION device.
Which command, when executed on the ION CLI, will output the configuration for all VRF route leak rules?

  1. dump vrf route_leak_rule all
  2. inspect vrf info all
  3. show routing-table vrf-leak
  4. debug vrf leak-database

Answer(s): A

Explanation:

This command displays all configured VRF route-leaking rules on the ION device, including the source VRF, destination VRF, VNIs, and permitted IP prefixes.
It allows the administrator to verify controlled route leaking between the PCI-Zone and Mgmt-Zone while confirming their routing isolation.


Reference:

https://docs.paloaltonetworks.com/prisma-sd-wan/ion-cli-reference/use-cli-commands/dump-comm ands/dump-vrf



A network design mandates segmentation at the routing level and traffic isolation across various services, such as teller cash registers, ATM traffic, guest Wi-Fi, and corporate applications.
Which command can be used to validate and display the Virtual Routing and Forwarding (VRF) route leak rules?

  1. show interface vrf route_leak_rule all
  2. dump vrf route_leak_rule
  3. inspect flow_browser vrf all
  4. inspect vrf route_leak_rule all

Answer(s): D

Explanation:

The command inspect vrf route_leak_rule all in Prisma SD-WAN is used to validate and display VRF route leak rules. This allows administrators to verify which routes are being shared between VRFs, ensuring proper segmentation and traffic isolation across different services such as teller systems, ATMs, guest Wi-Fi, and corporate applications.



In which modes can a Prisma SD-WAN branch be deployed?

  1. Testing, Control, POV
  2. Production, Control, Disabled
  3. Disabled, Analytics, Control
  4. POV, Production, Analytics

Answer(s): D

Explanation:

A Prisma SD-WAN branch can operate in POV (Proof of Value), Production, or Analytics modes.
-POV mode is used for evaluation and testing.
-Production mode enables full SD-WAN functionality for live traffic.
-Analytics mode allows traffic observation without influencing forwarding decisions, useful for assessment or gradual deployment.
-



A network engineer is monitoring a high availability (HA) pair of ION 7000 devices at a regional hub. During a maintenance window, the active device's control link interface is accidentally disabled, interrupting the heartbeat communication between the peers.
Which action does the standby ION device perform?

  1. It transitions to a standby-bypass mode that forwards all traffic to the data center ION for remote processing until the local peer recovers.
  2. It assumes the active role and issues a gratuitous ARP to redirect incoming frames to its own physical or virtual interfaces.
  3. It monitors the primary device's public WAN IP addresses and triggers a failover if those addresses become unreachable.
  4. It enters a dual-active state to load-balance traffic across both circuits until the controller resolves the split-brain condition.

Answer(s): B

Explanation:

In an ION high availability pair, loss of the HA control-link heartbeat causes the standby device to take over the active role when failover conditions are met. It then uses gratuitous ARP to update neighboring devices so traffic is redirected to the newly active ION interfaces.



A new Prisma SD-WAN site is deployed with one internet (ISP-1) and one MPLS circuit (Carrier-B). The public VPNs to the data center ION are up, but the private VPNs over MPLS transport are down.
Which mismatch is the root cause of the issue?

  1. Circuit category between the site and data center
  2. Circuit name between the site and data center
  3. Circuit speed between the site and data center
  4. WAN network between the site and data center

Answer(s): D

Explanation:

Private VPN formation over MPLS depends on matching WAN network definitions between the branch and data center sites. If the MPLS circuits are associated with different WAN networks, Prisma SD-WAN cannot establish the private overlay tunnels across that transport, even though public VPNs over the internet remain operational.



Which IONs can support Branch Gateway?

  1. 3102V, 3200, 1200S, 5200
  2. 1200, 3200, 9200, 7108V
  3. 3104V, 1200S, 5200, 7108V
  4. 9200, 3200, 5200, 7116V

Answer(s): D

Explanation:

Prisma SD-WAN Branch Gateway functionality is supported on higher-capacity ION models that can handle aggregation and gateway services for multiple branch connections. Models such as 9200, 3200, 5200, and 7116V are capable of acting as Branch Gateways, providing routing, security, and SD-WAN overlay termination for branch sites.



When an ION device has been claimed, the cloud-based controller generates and communicates with the device by which method?

  1. Manufacturer Installed Certificate (MIC)
  2. Existing customer public key infrastructure (KPI)
  3. Self-signed certificate
  4. Customer Installed Certificate (CIC)

Answer(s): A

Explanation:

When a Prisma SD-WAN ION device is claimed, the cloud-based controller communicates securely with the device using the Manufacturer Installed Certificate (MIC). The MIC is pre-installed by the manufacturer on the device, enabling secure authentication and encrypted communication with the Prisma SD-WAN cloud controller.



Share your comments for Palo Alto Networks SD-WAN-Engineer exam with other users:

C
CHINIMILLI SATISH
8/29/2023 6:22:00 AM

looking for 1z0-116

P
Pedro Afonso
1/15/2024 8:01:00 AM

in question 22, shouldnt be in the data (option a) layer?

P
Pushkar
11/7/2022 12:12:00 AM

the questions are incredibly close to real exam. you people are amazing.

A
Ankit S
11/13/2023 3:58:00 AM

q15. answer is b. simple

S
S. R
12/8/2023 9:41:00 AM

great practice

M
Mungara
3/14/2023 12:10:00 AM

thanks to this exam dumps, i felt confident and passed my exam with ease.

A
Anonymous
7/25/2023 2:55:00 AM

need 1z0-1105-22 exam

N
Nigora
5/31/2022 10:05:00 PM

this is a beautiful tool. passed after a week of studying.

A
Av dey
8/16/2023 2:35:00 PM

can you please upload the dumps for 1z0-1096-23 for oracle

M
Mayur Shermale
11/23/2023 12:22:00 AM

its intresting, i would like to learn more abouth this

J
JM
12/19/2023 2:23:00 PM

q252: dns poisoning is the correct answer, not locator redirection. beaconing is detected from a host. this indicates that the system has been infected with malware, which could be the source of local dns poisoning. location redirection works by either embedding the redirection in the original websites code or having a user click on a url that has an embedded redirect. since users at a different office are not getting redirected, it isnt an embedded redirection on the original website and since the user is manually typing in the url and not clicking a link, it isnt a modified link.

F
Freddie
12/12/2023 12:37:00 PM

helpful dump questions

D
Da Costa
8/25/2023 7:30:00 AM

question 423 eigrp uses metric

B
Bsmaind
8/20/2023 9:22:00 AM

hello nice dumps

B
beau
1/12/2024 4:53:00 PM

good resource for learning

S
Sandeep
12/29/2023 4:07:00 AM

very useful

K
kevin
9/29/2023 8:04:00 AM

physical tempering techniques

B
Blessious Phiri
8/15/2023 4:08:00 PM

its giving best technical knowledge

T
Testbear
6/13/2023 11:15:00 AM

please upload

S
shime
10/24/2023 4:23:00 AM

great question with explanation thanks!!

T
Thembelani
5/30/2023 2:40:00 AM

does this exam have lab sections?

S
Shin
9/8/2023 5:31:00 AM

please upload

P
priti kagwade
7/22/2023 5:17:00 AM

please upload the braindump for .net

R
Robe
9/27/2023 8:15:00 PM

i need this exam 1z0-1107-2. please.

C
Chiranthaka
9/20/2023 11:22:00 AM

very useful!

N
Not Miguel
11/26/2023 9:43:00 PM

for this question - "which three type of basic patient or member information is displayed on the patient info component? (choose three.)", list of conditions is not displayed (it is displayed in patient card, not patient info). so should be thumbnail of chatter photo

A
Andrus
12/17/2023 12:09:00 PM

q52 should be d. vm storage controller bandwidth represents the amount of data (in terms of bandwidth) that a vms storage controller is using to read and write data to the storage fabric.

R
Raj
5/25/2023 8:43:00 AM

nice questions

M
max
12/22/2023 3:45:00 PM

very useful

M
Muhammad Rawish Siddiqui
12/8/2023 6:12:00 PM

question # 208: failure logs is not an example of operational metadata.

S
Sachin Bedi
1/5/2024 4:47:00 AM

good questions

K
Kenneth
12/8/2023 7:34:00 AM

thank you for the test materials!

H
Harjinder Singh
8/9/2023 4:16:00 AM

its very helpful

S
SD
7/13/2023 12:56:00 AM

good questions

AI Tutor 👋 I’m here to help!