When setting up an AOS-CX VSX pair, which information does the Inter-Switch Protocol synchronize in the configuration created?
Answer(s): D
What is enabled by LLDP-MED?
Answer(s): A
LLDP-MED (Link Layer Discovery Protocol – Media Endpoint Discovery) allows switches to automatically assign and configure the correct Voice VLAN to VoIP phones, enabling seamless voice network deployments.
Refer to the output from a CX6100 switch:What is the correct detail that can be observed from the output above?
Answer(s): C
The Rx Power is shown as -40.00 dBm (0.0001 mW), which is extremely low and far below operational thresholds. Additionally, alarms indicate "Rx Power low alarm," "Rx Power low warning," and "Rx loss of signal," confirming that the link is down due to insufficient received signal strength.
What is true regarding 802.11k?
In a CX 8325, how do you configure the IP address 10.10.10.1 for the interface in default state for interface SVI 100 access and port 1/1/1?
Answer(s): B
To configure an SVI with IP address 10.10.10.1 on VLAN 100 and assign port 1/1/1 as an access port in VLAN 100 on the CX 8325, you configure the VLAN interface with the IP address and set the port as an access port for that VLAN. This enables both routing and switching for hosts connected to port 1/1/1 on VLAN 100.
Your customer currently has two (2) 5406 modular switches with MSTP configured as their core switches. You are proposing a new solution.What would you explain regarding the AOS-CX VSX switch pair when the Spanning-tree needs to be set up?
In AOS-CX VSX, to synchronize spanning-tree configuration (such as MSTP) between the VSX pair, you must enable vsx-sync stp-global in VSX mode. This ensures both switches have consistent spanning-tree settings, unlike classic modular switches where spanning-tree configuration is manually matched.
A customer has several hundred wireless IoT devices and is looking for an authentication solution that meets the following requirements:-The wireless traffic between the IoT devices and the Access Point must be encrypted -Unique passphrase per device -Use fingerprint information to perform role-based accessWhich solution will address the customer’s requirements? (Choose two.)
Answer(s): A,D
MPSK (Multi Pre-Shared Key) provides unique passphrases per device, ensuring each IoT device has an individual key and encrypted wireless communication.ClearPass Policy Manager enables advanced authentication (including fingerprinting), dynamic role-based access, and integrates with MPSK or RADIUS for per-device policies. Together, they meet all listed requirements: encryption, unique credentials, and fingerprint-based access control.
A large retail client is looking to generate a rich set of contextual data based on the location information of wireless clients in their stores.Which standard uses Round Trip Time (RTT) and Fine Time Measurements (FTM) to calculate the distance a client is from an AP?
802.11mc introduces Fine Timing Measurement (FTM), which uses Round Trip Time (RTT) calculations between the client and the AP to accurately determine the client’s distance from the access point, enabling precise location-based services and contextual data collection.
Share your comments for HP HPE7-A01 exam with other users:
question # 208: failure logs is not an example of operational metadata.
good questions
thank you for the test materials!
its very helpful
good questons
i need the dumb of the hcip security v4.0 exam
upload the dump please
yes, iam looking this
please upload cima e2 managing performance dumps
wonderful questions
i used this site since 2000, still great to support my career
why is the answer to "which of the following is required by scrum?" all of the following stated below since most of them are not mandatory? sprint retrospective. members must be stand up at the daily scrum. sprint burndown chart. release planning.
great job. hope this helps out.
upload please. many thanks!
this is so interesting
great material thanks
anyone who wrote this exam recently
ok they re good
relevant questions
please post
q:42 there has to be a image in the question to choose what does it mean from the options
looking for cphq dumps, where can i find these for free? please and thank you.
@aarun , thanks for the information. it would be great help if you share your email
1z0-1078-23 need this dumps
i gave the microsoft azure az-500 tests and prepared from this site as it has latest mock tests available which helped me evaluate my performance and score 919/1000
i cannot see the button to go to the questions
q-6 ans-b correct. https://docs.paloaltonetworks.com/pan-os/9-1/pan-os-cli-quick-start/use-the-cli/commit-configuration-changes
very nice very nice
please help us with 1z0-1107-2 dumps
please upload the practice questions
need this dumps
preparing for this exam is overwhelming. you cannot pass without the help of these exam dumps.
Keeping this site free takes real effort. We constantly battle automated scraping and unauthorized content copying. A quick account helps us protect the community and keep the site free.
To continue studying for your HPE7-A01, please sign in or create a free account.