Cisco® 350-401 Exam (page: 38)
Cisco® Implementing Enterprise Network Core Technologies (ENCOR)
Updated on: 10-Jan-2026

Viewing Page 38 of 214

A company has an existing Cisco 5520 HA cluster using SSO. An engineer deploys a new single Cisco Catalyst 9800 WLC to test new features. The engineer successfully configures a mobility tunnel between the 5520 cluster and 9800 WLC. Clients connected to the corporate WLAN roam seamlessly between access points on the 5520 and 9800 WLC. After a failure on the primary 5520 WLC, all WLAN services remain functional; however, clients cannot roam between the 5520 and 9800 controllers without dropping their connection.
Which feature must be configured to remedy the issue?

  1. mobility MAC on the 5520 cluster
  2. mobility MAC on the 9800 WLC
  3. new mobility on the 5520 cluster
  4. new mobility on the 9800 WLC

Answer(s): B



Refer to the exhibit.
Which configuration change ensures that R1 is the active gateway whenever it is in a functional state for the 172.30.110.0/24 network?

  1. R2 standby 1 priority 90 standby 1 preempt
  2. R2 standby 1 priority 100 standby 1 preempt
  3. R1 standby 1 preempt R2 standby 1 priority 90
  4. R1 standby 1 preempt R2 standby 1 priority 100

Answer(s): C



A customer has completed the installation of a Wi-Fi 6 greenfield deployment at their new campus. They want to leverage Wi-Fi 6 enhanced speeds on the trusted employee WLAN. To configure the employee WLAN, which two Layer 2 security policies should be used? (Choose two.)

  1. WPA2 (AES)
  2. 802.1X
  3. OPEN
  4. WEP
  5. WPA (AES)

Answer(s): A,B



Which two actions, when applied in the LAN network segment, will facilitate Layer 3 CAPWAP discovery for lightweight AP? (Choose two.)

  1. Utilize DHCP option 43.
  2. Utilize DHCP option 17.
  3. Configure an ip helper-address on the router interface.
  4. Enable port security on the switch port.
  5. Configure WLC IP address on LAN switch

Answer(s): A,C



Refer to the exhibit.
Which action resolves the EtherChannel issue between SW2 and SW3?

  1. Configure switchport mode trunk on SW2.
  2. Configure switchport nonegotiate on SW3.
  3. Configure channel-group 1 mode desirable on both interfaces.
  4. Configure channel-group 1 mode active on both interfaces.

Answer(s): C



Viewing Page 38 of 214



Share your comments for Cisco® 350-401 exam with other users:

Big Dog 6/24/2023 4:47:00 PM

question 13 should be dhcp option 43, right?
UNITED STATES


BigMouthDog 1/22/2022 8:17:00 PM

hi team just want to know if there is any update version of the exam 350-401
AUSTRALIA


Desmond 1/5/2023 9:11:00 PM

i just took my oracle exam and let me tell you, this exam dumps was a lifesaver! without them, iam not sure i would have passed. the questions were tricky and the answers were obscure, but the exam dumps had everything i needed. i would recommend to anyone looking to pass their oracle exams with flying colors (and a little bit of cheating) lol.
SINGAPORE


whoAreWeReally 12/19/2023 8:29:00 PM

took the test last week, i did have about 15 - 20 word for word from this site on the test. (only was able to cram 600 of the questions from this site so maybe more were there i didnt review) had 4 labs, bgp, lacp, vrf with tunnels and actually had to skip a lab due to time. lots of automation syntax questions.
EUROPEAN UNION


mrtom33 11/20/2023 4:51:00 AM

i prepared for the eccouncil 350-401 exam. i scored 92% on the test.
Anonymous


Nigora 5/31/2022 10:05:00 PM

this is a beautiful tool. passed after a week of studying.
UNITED STATES