Cisco 300-615 Exam Questions in PDF and Online

QUESTION: 16

Refer to the exhibit. An engineer troubleshoots the HSRP configuration and notes that the remote end uses HSRP version 1. The engineer sets the local HSRP to version 1, but the problem continues. Which action resolves the issue?

Change the local group number to 255 or less and request that the remote data center matches the group number in its configuration.
Set the local group number as 300 in the remote data center configuration.
Run version 1 and version 2 HSRP on VLAN300 in the local data center.
Reduce the priority of the local HSRP to below 100 to force the local HSRP to standby and then change the version to version 1.

Answer(s): A

Reveal Solution Next Question

QUESTION: 17

Refer to the exhibit. A PC belongs to VLAN 68. The user experiences a large amount of packet loss when communicating with hosts that are outside of VLAN 68. Which action resolves the problem?

Replace HSRP with GLBP.
Remove the HSRP configuration.
Enable the peer-gateway feature.
Configure iparp synchronization on both switches.

Answer(s): C

Reference:

https://community.cisco.com/t5/networking-documents/peer-gateway-feature-on-the-nexus-7000/ta-p/3113290

Reveal Solution Next Question

QUESTION: 18

An engineer troubleshoots a VXLAN EVPN data center. The applications in the data center fail to reach the DNS server that is located at IP 10.10.10.10. The engineer examines the BGP EVPN routing table and notes that the IP prefix route that covers the DNS server is missing. Which action resolves the issue?

Set the IP prefix route to represent [5]:[0]:[0]:[32]:[10.10.10.10]/224 in the routing table.
Set the IP prefix route to represent [2]:[0]:[0]:[48]:[0050.569f.1285]:[0]:[0.0.0.0]/216 in the routing table.
Configure an IP ARP entry to represent [2]:[0]:[0]:[48]:[0050.569f.1285]:[32]:[10.10.10.10]/272 in the routing table.
Configure an IP ARP entry to represent [4]:[0300.0000.00fc.bd00.0309]:[32]:[10.10.10.10]/136 in the routing table.

Answer(s): A

Reveal Solution Next Question

QUESTION: 19

Refer to the exhibit. An engineer must connect N2K-Fex-1 and N5K-Core-1 so that the traffic flow between the two devices uses load balancing. After inspecting the statistics of the interconnecting interfaces, the engineer concludes that only one link is used. Which action resolves the problem?