Amazon
Avaya
Cisco
CompTIA
CrowdStrike
EC-Council
EXIN
Fortinet
Google
ISC
ISC2
ITIL
Juniper
Microsoft
NVIDIA
Okta
Palo Alto Networks
Salesforce
SAP
ServiceNow
All Vendors
  1. Home
  2. Cisco
  3. 200-301

Cisco Certified Network Associate (CCNA) 200-301 Exam Questions in PDF

Free Cisco 200-301 Dumps Questions (page: 56)

200-301 PDF — 1395 Questions

Refer to the exhibit. An engineer has started to configure replacement switch SW1. To verify part of the configuration, the engineer issued the commands as shown and noticed that the entry for PC2 is missing. Which change must be applied to SW1 so that PC1 and PC2 communicate normally?

  1. SW1(config)#interface fa0/2 SW1(config-if)#no switchport access vlan 2 SW1(config-if)#no switchport trunk allowed vlan 3 SW1(config-if)#switchport trunk allowed vlan 2
  2. SW1(config)#interface fa0/2 SW1(config-if)#no switchport access vlan 2 SW1(config-if)#switchport trunk native vlan 2 SW1(config-if)#switchport trunk allowed vlan 3
  3. SW1(config)#interface fa0/2 SW1(config-if)#no switchport mode trunk SW1(config-if)#no switchport trunk allowed vlan 3 SW1(config-if)#switchport mode access
  4. SW1(config)#interface fa0/1 SW1(config-if)#no switchport access vlan 2 SW1(config-if)#switchport access vlan 3 SW1(config-if)#switchport trunk allowed vlan 2

Answer(s): C



Refer to the exhibit. Which switch becomes the root of the spanning tree?


Switch 1
BID: 32778 0018.184e.3c00

Switch 2
BID: 24586 001a.e3ff.a680

Switch 3
BID: 28682 0022.55cf.cc00

Switch 4
BID: 64000 4e15.8403.08f

  1. Switch 1
  2. Switch 2
  3. Switch 3
  4. Switch 4

Answer(s): B



DRAG DROP (Drag and Drop is not supported)
Drag and drop the facts about wireless architectures from the left onto the types of access point on the right. Not all options are used.
Select and Place:

  1. See Explanation section for answer.

Answer(s): A

Explanation:



Refer to the exhibit. An engineer is configuring a Layer 3 port-channel interface with LACP. The configuration on the first device is complete, and it is verified that both interfaces have registered the neighbor device in the CDP table. Which task on the neighbor device enables the new port channel to come up without negotiating the channel?

  1. Configure the IP address of the neighboring device.
  2. Bring up the neighboring interfaces using the no shutdown command.
  3. Change the EtherChannel mode on the neighboring interfaces to auto.
  4. Modify the static EtherChannel configuration of the device to passive mode.

Answer(s): D



Refer to the exhibit. Which configuration establishes a Layer 2 LACP EtherChannel when applied to both switches?

  1. Interface range G1/1 “" 1/3 switchport mode trunk channel-group 1 mode active no shutdown
  2. Interface range G1/1 “" 1/3 switchport mode access channel-group 1 mode passive no shutdown
  3. Interface range G1/1 “" 1/3 switchport mode trunk channel-group 1 mode desirable no shutdown
  4. Interface range G1/1 “" 1/3 switchport mode access channel-group 1 mode on no shutdown

Answer(s): D



Viewing page 56 of 281

Share your comments for Cisco 200-301 exam with other users:

A
Anonymous User
4/14/2026 12:31:34 PM

Question 2:
For question 2, the key concept is the Longest Prefix Match. Routers pick the route whose subnet mask is the most specific (largest prefix length) that still matches the destination IP.
From the options:

  • A) 10.10.10.0/28 ? 10.10.10.0–10.10.10.15
  • B) 10.10.13.0/25 ? 10.10.13.0–10.10.13.127
  • C) 10.10.13.144/28 ? 10.10.13.144–10.10.13.159
  • D) 10.10.13.208/29 ? 10.10.13.208–10.10.13.215

The destination Host A’s IP must fall within 10.10.13.208–10.10.13.215 for the /29 to be the best match. Since /29 is the longest prefix among the matching options, Router1 will use 10.10.13.208/29.
Thus, the correct answer is D.

Canada
Y
yenvti2@gmail.com
8/12/2023 7:56:00 PM

very helpful for exam preparation

Anonymous
X
Xunil
6/12/2023 3:04:00 PM

great job whoever put this together, for the greater good! thanks!

Anonymous
X
x-men
5/23/2023 1:02:00 AM

q23, its an array, isnt it? starts with [ and end with ]. its an array of objects, not object.

UNITED STATES
D
Dan
8/10/2023 4:19:00 PM

question 129 is completely wrong.

UNITED STATES
D
Da_costa
8/1/2023 5:28:00 PM

these are free brain dumps i understand, how can one get free pdf

Anonymous
D
Da Costa
8/27/2023 11:43:00 AM

question 128 the answer should be static not auto

Anonymous
C
CiscoStudent
11/15/2023 5:29:00 AM

in question 272 the right answer states that an autonomous acces point is "configured and managed by the wlc" but this is not what i have learned in my ccna course. is this a mistake? i understand that lightweight aps are managed by wlc while autonomous work as standalones on the wlan.

Anonymous
B
Berihun Desalegn Wonde
7/13/2023 11:00:00 AM

all questions are more important

Anonymous
R
RAWI
7/9/2023 4:54:00 AM

is this dump still valid? today is 9-july-2023

SWEDEN
B
Berihun
7/13/2023 7:29:00 AM

all questions are so important and covers all ccna modules

Anonymous
N
Nico
4/23/2023 11:41:00 PM

my 3rd purcahse from this site. these exam dumps are helpful. very helpful.

ITALY
D
Da Costa
8/25/2023 7:30:00 AM

question 423 eigrp uses metric

Anonymous
G
Gurdeep
1/18/2024 4:00:15 PM

This is one of the most useful study guides I have ever used.

CANADA
AI Tutor 👋 I’m here to help!