Amazon
Anthropic
Avaya
Cisco
CompTIA
CrowdStrike
EC-Council
EXIN
Fortinet
Google
ISC
ISC2
ITIL
Juniper
Microsoft
NVIDIA
Palo Alto Networks
Salesforce
SAP
VMware
All Vendors

Test Prep Armed Services Vocational Aptitude Battery Test: General Science, Arithmetic Reasoning, Word Knowledge, Paragraph Comprehension, Mathematics Knowledge, Electronics Information, Automotive & Shop Information, Mechanical Comprehension, Assembling Objects ASVAB Test Dumps in PDF

Free Test Prep ASVAB Test Real Questions (page: 69)

ASVAB Test PDF — 1893 Questions

The purpose of the drive shaft is to connect the __________.

  1. piston to the transmission
  2. differential to the transmission
  3. flywheel to the crankshaft
  4. camshaft to the crankshaft

Answer(s): B

Explanation:

On a rear-wheel-drive vehicle, the driveshaft transmits power from the transmission to the differential. The flywheel is bolted directly to the crankshaft.



The order in which an engine's spark plugs fire is established by the order in which the __________.

  1. plugs are mounted in the engine.
  2. plug leads are connected to the distributor cap.
  3. condenser is connected.
  4. contact points are opened.

Answer(s): B

Explanation:

Spark plug leads must be installed in the correct tower of the cap to ensure the proper firing order. The firing order is the order that the spark plugs ignite the air/fuel mixture in the combustion chamber. A typical firing order for a six-cylinder engine is 1-5-3-6-2-4.



The terminals exposed on the ignition induction coil are __________.

  1. two secondary and one primary
  2. one secondary and one primary
  3. one secondary and two primary
  4. two secondary and two primary

Answer(s): C

Explanation:

On a conventional ignition coil, the center tower is the secondary or high-voltage terminal. The two small studs at the top of the coil are primary or low-voltage terminals.



Battery electrolyte is a mixture of distilled water and __________.

  1. baking soda
  2. sulfuric acid
  3. lead peroxide
  4. carbon particles

Answer(s): B

Explanation:

Battery electrolyte is a mixture of approximately 60% distilled water and 40% sulfuric acid.



The brushes in an alternator ride on __________.

  1. the commutator
  2. the stator
  3. slip rings
  4. the heat sink

Answer(s): C

Explanation:

Two slip rings are mounted on the rotor shaft. Two brushes ride on the slip rings and deliver electrical energy to the rotor windings.



PDF
Viewing page 69 of 380

Share your comments for Test Prep ASVAB Test exam with other users:

A
AI Tutor Explanation
4/21/2026 8:48:36 AM

Question 3:

  • False is the correct answer (Option B).

Why:
  • In Snowflake, a database is a metadata object that exists within a single Snowflake account. Accounts are isolated—there isn’t one database that lives in multiple accounts.
  • You can access data across accounts via data sharing or database replication, but these create separate database objects in the other accounts (e.g., a database in the consumer account created from a share), not a single shared database across accounts.

So a single database cannot exist in more than one Snowflake account.

Thane, India
A
Anonymous User
4/16/2026 10:54:18 AM

Question 1:

  • Correct answer: E — date = sys.argv[1]
  • Why this is correct:
- When a Databricks Job passes parameters to a notebook, those parameters are supplied to the notebook's Python process as command-line arguments. The first argument after the script name is sys.argv[1], so date = sys.argv[1] captures the passed date value directly.
  • How it compares to other options:
- date = spark.conf.get("date") reads from Spark config, not from job parameters. - input() waits for user input at runtime, which isn’t how job parameters are provided. - date = dbutils.notebooks.getParam("date") would work if the notebook were invoked via dbutils.notebook.run with parameters, not

Innisfil, Canada
A
Anonymous User
4/15/2026 4:42:07 AM

Question 528:

  • Correct answer: NSG flow logs for NSG1 (Option B)

  • Why:
- Traffic Analytics uses NSG flow logs to analyze traffic patterns. You must have NSG flow logs enabled for the NSGs you want to monitor. - An Azure Log Analytics workspace is also required to store and query the traffic data. - Network Watcher must be available in the subscription for traffic analytics to function.
  • What to configure (brief steps):
- Ensure Network Watcher is enabled in the East US region (for the subscription/region). - Enable NSG flow logs on NSG1. - Ensure a Log Analytics workspace exists and is accessible (read/write) so Traffic Analytics can store and query logs.
  • Why other options aren’t correct:
- “Diagnostic settings for VM1” or “Diagnostic settings for NSG1” alone don’t guarantee flow logs are captured and sent to Log Analytics, which Traffic Analytics relies on. - “Insights for VM1” is not how Traffic Analytics collects traffic data.

Hamburg, Germany
A
Anonymous User
4/15/2026 2:43:53 AM

Question 23:
The correct answer is Domain admin (option B), not Fabric admin.

  • Domain admin provides domain-level management: create domains/subdomains and assign workspaces within those domains, which matches the tasks while following least privilege.
  • Fabric admin is global-level access and is more privileges than needed for this scenario (it would grant broader control across the Fabric environment).

Kottayam, India
A
Anonymous User
4/14/2026 12:31:34 PM

Question 2:
For question 2, the key concept is the Longest Prefix Match. Routers pick the route whose subnet mask is the most specific (largest prefix length) that still matches the destination IP.
From the options:

  • A) 10.10.10.0/28 ? 10.10.10.0–10.10.10.15
  • B) 10.10.13.0/25 ? 10.10.13.0–10.10.13.127
  • C) 10.10.13.144/28 ? 10.10.13.144–10.10.13.159
  • D) 10.10.13.208/29 ? 10.10.13.208–10.10.13.215

The destination Host A’s IP must fall within 10.10.13.208–10.10.13.215 for the /29 to be the best match. Since /29 is the longest prefix among the matching options, Router1 will use 10.10.13.208/29.
Thus, the correct answer is D.

Canada
S
srameh
4/14/2026 10:09:29 AM

Question 3:

  • Correct answer: Phase 4, Post Accreditation

  • Explanation:
- In DITSCAP, the four phases are: - Phase 1: Definition (concept and requirements) - Phase 2: Verification (design and testing) - Phase 3: Validation (fielding and evaluation) - Phase 4: Post Accreditation (ongoing operations and lifecycle management) - The description—continuing operation of an accredited IT system and addressing changing threats throughout its life cycle—fits the Post Accreditation phase, which covers operations, maintenance, monitoring, and reauthorization as threats and environment evolve.

France
O
onibokun10
4/13/2026 7:50:14 PM

Question 129:
Correct answer: CNAME

  • A CNAME record creates an alias for a domain, so newapplication.comptia.org will resolve to whatever IP address www.comptia.org resolves to. This ensures both names point to the same resource without duplicating the IP.
  • Why not the others:
- SOA defines authoritative information for a zone. - MX specifies mail exchange servers. - NS designates name servers for a zone.
  • Notes: The alias name (newapplication.comptia.org) should not have other records if you use a CNAME for it, and CNAMEs aren’t used for the zone apex (root) domain. This scenario uses a subdomain, so a CNAME is appropriate.

Swindon, United Kingdom
A
Anonymous User
4/13/2026 6:29:58 PM

Question 1:

  • Correct answer: C

  • Why this is best:
- Uses OS Login with IAM, so SSH access is granted via Google accounts rather than distributing per-user SSH keys. - Granting the compute.osAdminLogin role to a Google group gives admin access to all team members in a centralized, auditable way. - Access is auditable: Cloud Audit Logs show who accessed which VM, satisfying the security requirement to determine who accessed a given instance.
  • How it works:
- Enable OS Login on the project/instances (enable-oslogin metadata). - Add the team’s

Germany
A
Anonymous User
4/13/2026 1:00:51 PM

Question 2:

  • Answer: D. Azure Advisor

  • Why: To view security-related recommendations for resources in the Compute and Apps area (including App Service Web Apps and Functions), you use Azure Advisor. Advisor surfaces personalized best-practice recommendations across resources, including security, and shows which resources are affected and the severity.

  • Why not the others:
- Azure Log Analytics is for ad-hoc querying of telemetry, not for viewing security recommendations. - Azure Event Hubs is for streaming telemetry data, not for security recommendations.
  • Quick tip: In the portal, navigate to Azure Advisor and check the Security recommendations for App Services to see actionable items and affe

    Brazil
D
Don
4/11/2026 5:36:42 AM

Recommend using AI for Solutions rather the Answer(s) submitted here

Hamburg, Germany
M
Mogae Malapela
4/8/2026 6:37:56 AM

This is very interesting

Gaborone, Botswana
A
Anon
4/6/2026 5:22:54 PM

Are these the same questions you have to pay for in ExamTopics?

Amsterdam, The Netherlands
L
LRK
3/22/2026 2:38:08 PM

For Question 7 - while the answer description indicates the correct answer, the option no. mentioned is incorrect. Nice and Comprehensive. Thankyou

Paris, France
R
Rian
3/19/2026 9:12:10 AM

This is very good and accurate. Explanation is very helpful even thou some are not 100% right but good enough to pass.

United States
G
Gerrard
3/18/2026 6:58:37 AM

The DP-900 exam can be tricky if you aren't familiar with Microsoft’s specific cloud terminology. I used the practice questions from free-braindumps.com and found them incredibly helpful. The site breaks down core data concepts and Azure services in a way that actually mirrors the real test. As a resutl I passed my exam.

United States
V
Vineet Kumar
3/6/2026 5:26:16 AM

interesting

Anonymous
J
Joe
1/20/2026 8:25:24 AM

Passed this exam 2 days ago. These questions are in the exam. You are safe to use them.

UNITED STATES
N
NJ
12/24/2025 10:39:07 AM

Helpful to test your preparedness before giving exam

Anonymous
A
Ashwini
12/17/2025 8:24:45 AM

Really helped

Anonymous
J
Jagadesh
12/16/2025 9:57:10 AM

Good explanation

INDIA
S
shobha
11/29/2025 2:19:59 AM

very helpful

INDIA
P
Pandithurai
11/12/2025 12:16:21 PM

Question 1, Ans is - Developer,Standard,Professional Direct and Premier

Anonymous
E
Einstein
11/8/2025 4:13:37 AM

Passed this exam in first appointment. Great resource and valid exam dump.

Anonymous
D
David
10/31/2025 4:06:16 PM

Today I wrote this exam and passed, i totally relay on this practice exam. The questions were very tough, these questions are valid and I encounter the same.

UNITED STATES
T
Thor
10/21/2025 5:16:29 AM

Anyone used this dump recently?

NEW ZEALAND
V
Vladimir
9/25/2025 9:11:14 AM

173 question is A not D

Anonymous
K
khaos
9/21/2025 7:07:26 AM

nice questions

Anonymous
K
Katiso Lehasa
9/15/2025 11:21:52 PM

Thanks for the practice questions they helped me a lot.

Anonymous
E
Einstein
9/2/2025 7:42:00 PM

Passed this exam today. All questions are valid and this is not something you can find in ChatGPT.

UNITED KINGDOM
V
vito
8/22/2025 4:16:51 AM

i need to pass exam for VMware 2V0-11.25

Anonymous
M
Matt
7/31/2025 11:44:40 PM

Great questions.

UNITED STATES
O
OLERATO
7/1/2025 5:44:14 AM

great dumps to practice for the exam

SOUTH AFRICA
A
Adekunle willaims
6/9/2025 7:37:29 AM

How reliable and relevant are these questions?? also i can see the last update here was January and definitely new questions would have emerged.

Anonymous
A
Alex
5/24/2025 12:54:15 AM

Can I trust to this source?

Anonymous
AI Tutor 👋 I’m here to help!