Fast Track - Applying Aruba Switching Fundamentals for Mobility Exam Questions PDF download

QUESTION: 6

A network administrator has set up a link between two ArubaOS switches. Both switches have an IP address in VLAN 1 and can ping each other in VLAN 1. The administrator then creates VLAN 2 and tags it on the same link of both switches.

How can the administrator verify that the connectivity in VLAN 2 is functional between the two switches7 Use either LLDP or ARP to test connectivity.
Use LLDP to test connectivity.
Assign each switch an IP address in VLAN 2. and use ICMP to test connectivity.
Assign each switch an IP address in VLAN 2. and use LLDP to test connectivity.

Answer(s): B

Reveal Solution Next Question

QUESTION: 7

A port on an ArubaOS switch has its default spanning tree settings. When is the port defined as a spanning tree edge port?

when the switch and the connected switch run MSTP but have different region settings
when the switch runs MSTP but the connected switch runs RSTP
when the port fails to receive BPDUs on the port within a set period of time
when the port is part of a VLAN that is dedicated to that port alone

Answer(s): B

Reveal Solution Next Question

QUESTION: 8

A network administrator suspects that interfaces in a link aggregation have been accidentally connected to multiple switches. The administrator wants to find the hostnames of the switches on the other side of the interfaces. How can the administrator find this information?

Use the show lace command to view LACP information.
Use the show trunks command to view link aggregation information.
Use the show interface command to view detailed interface status.
Use the show lldp info remote-device command to view LLDP information.

Answer(s): D

Reveal Solution Next Question

QUESTION: 9

An Aruba Virtual Switching Framework (VSF) fabric has 10GbE interfaces assigned to its VSF link. The network administrator wants to change the link to use 40GbE interfaces. Which procedure follows the best practices and requirements to set up the VSF links?

Create an LACP link aggregation on the 40GbE interfaces, and then add them to the VSF link.
Shut down the standby member, remove the VSF link, and then re-create the link with only 40GbE interfaces.
Create a second VSF link that uses the 40GbE interfaces, and then remove the first VSF link.
Add the 40GbE interfaces to the VSF link, and then remove the 10GbE interfaces from the link.

Answer(s): A

Reveal Solution Next Question

QUESTION: 10

A network administrator has set up OSPF to enable communications between subnets 10.1.4.0/24 and 10.1.8.0/24.
Swffch-4 is not receiving a route to 10.1.4.0/24.
What should the network administrator do to help fix this issue?

Fix the router IDs on al switches so that they are valid.
Enable OSPF on VLAN 4 on Switch-1.
Configure Switch-1 with a better DR priority on VLANs 100 and 101.
Verify that Switch-2 and Switch-3 are part of the backbone area.

Answer(s): B

Reveal Solution Next Question

HP Fast Track - Applying Aruba Switching Fundamentals for Mobility HPE2-Z39 Dumps in PDF

Free HP HPE2-Z39 Real Questions (page: 11)

QUESTION: 6

QUESTION: 7

QUESTION: 8

QUESTION: 9

QUESTION: 10