EMC E20-393 Exam (page: 6)
EMC Unity Solutions Specialist Exam for Implementation Engineers
Updated on: 25-Dec-2025

Viewing Page 6 of 61

How is encryption set for a Unity storage system?

  1. Clicking the “Mode” checkbox on the Manage Encryption page
  2. Selecting “Status” on the Manage Encryption page
  3. Automatically set at the factory
  4. First time the license is applied

Answer(s): D

Explanation:

D@RE is included by default on Unity arrays and included in the Unity license file unless otherwise requested during ordering. Therefore, all that is needed to activate D@RE is to install the D@RE enabled license file. The license installation process is not specific to D@RE, and is required to be performed before using the array.
When logging into Unisphere for the first time, license installation appears as a step of the Unisphere Configuration Wizard, prompting the administrator to install the license file obtained from EMC. If this license file includes D@RE functionality, D@RE will be enabled once the license file is installed successfully

Note: Unity storage systems address sensitive data concerns through controller-based Data at Rest Encryption (D@RE), which encrypts stored data as it is written to disk.
D@RE is a license controlled feature available by default on Unity storage systems, and, being designed to be largely invisible to administrative end users, requires almost no effort to enable or manage. Enabling the feature or backing up the encryption keys externally takes just seconds, and redundant keystore backups stored on array ensure that user data is always as available as it is secure.



A system administrator experienced a power failure in their environment. To which device will cache de-stage?

  1. M.2 SSD on each Storage Processor
  2. First four disks in the Disk Processor Enclosure
  3. Cache does not need to de-stage as it is now non-volatile
  4. Backup Battery Unit will keep the data alive in cache

Answer(s): A



A service provider is installing a Unity storage system for an end-user. The end-user is concerned about network security and will not allow the service provider access to the network.
How can the service provider set a static IP address for the Unity storage system management interface?

  1. Use the embedded InitCLI tool
  2. Connect directly to the service ports and configure the networking through UEMCLI
  3. Use an IPMI serial over LAN connection
  4. Use the Connection Utility to create a configuration file

Answer(s): B

Explanation:

The svc_initial_config UEMCLI command sets up initial system configuration. It configures a management IP address when the Connection Utility (CU) is not available on the network. If an address is set, this command can also change the management IPv4 and IPv6 configuration mode. It attempts to configure the system with the given friendly name and/or network parameters.

Note: The Unisphere CLI (UEMCLI) is a tool that provides us with the CLI access to perform the same actions as one would on the Unisphere web interface.


Reference:

https://www.emc.com/collateral/TechnicalDocument/docu69328.pdf (page 60)



Which task must be performed on the storage system in order to access a file system read/write snapshot?

  1. Configure Host Access to the LUN snapshots
  2. Configure the NFS/SMB share to the file system snapshot
  3. Connect to the NFS/SMB share of the snapshot
  4. Perform the snapshot “Attach to Host” operation

Answer(s): B

Explanation:

Read-write snapshots can be made available to hosts as separate shares.
The Shared property is applicable to file snapshots only, and indicates whether the snapshot is currently available to clients as a share. The default value is No, and changes to Yes when the read-write file system snapshot is used to create shares. For read-only file system snapshots, this property is always set to No.

Share – A named, mountable instance of file-level storage, accessible through a file system or VMware NFS Datastore. Each share is accessible through the protocol (NFS or SMB) defined for the file system where it resides.



Which severity level alerts for a fault condition that has occurred, has minor impact on the system, and does not need to be fixed immediately?

  1. Critical
  2. Notice
  3. Error
  4. Warning

Answer(s): D

Explanation:

Event Severity levels are: critical, error, warning, info.



Viewing Page 6 of 61



Share your comments for EMC E20-393 exam with other users:

SB 9/12/2023 5:15:00 AM

i was hoping if you could please share the pdf as i’m currently preparing to give the exam.
Anonymous


Jagjit 8/26/2023 5:01:00 PM

i am looking for oracle 1z0-116 exam
UNITED STATES


S Mallik 11/27/2023 12:32:00 AM

where we can get the answer to the questions
Anonymous


PiPi Li 12/12/2023 8:32:00 PM

nice questions
NETHERLANDS


Dan 8/10/2023 4:19:00 PM

question 129 is completely wrong.
UNITED STATES


gayathiri 7/6/2023 12:10:00 AM

i need dump
UNITED STATES


Deb 8/15/2023 8:28:00 PM

love the site.
UNITED STATES


Michelle 6/23/2023 4:08:00 AM

can you please upload it back?
Anonymous


Ajay 10/3/2023 12:17:00 PM

could you please re-upload this exam? thanks a lot!
Anonymous


him 9/30/2023 2:38:00 AM

great about shared quiz
Anonymous


San 11/14/2023 12:46:00 AM

goood helping
Anonymous


Wang 6/9/2022 10:05:00 PM

pay attention to questions. they are very tricky. i waould say about 80 to 85% of the questions are in this exam dump.
UNITED STATES


Mary 5/16/2023 4:50:00 AM

wish you would allow more free questions
Anonymous


thomas 9/12/2023 4:28:00 AM

great simulation
Anonymous


Sandhya 12/9/2023 12:57:00 AM

very g inood
Anonymous


Agathenta 12/16/2023 1:36:00 PM

q35 should be a
Anonymous


MD. SAIFUL ISLAM 6/22/2023 5:21:00 AM

sap c_ts450_2021
Anonymous


Satya 7/24/2023 3:18:00 AM

nice questions
UNITED STATES


sk 5/13/2023 2:10:00 AM

ecellent materil for unserstanding
INDIA


Gerard 6/29/2023 11:14:00 AM

good so far
Anonymous


Limbo 10/9/2023 3:08:00 AM

this is way too informative
BOTSWANA


Tejasree 8/26/2023 1:46:00 AM

very helpfull
UNITED STATES


Yolostar Again 10/12/2023 3:02:00 PM

q.189 - answers are incorrect.
Anonymous


Shikha Bakra 9/10/2023 5:16:00 PM

awesome job in getting these questions
AUSTRALIA


Kevin 10/20/2023 2:01:00 AM

i cant find aws certified practitioner clf-c01 exam in aws website but i found aws certified practitioner clf-c02 exam. can everyone please verify the difference between the two clf-c01 and clf-c02? thank you
UNITED STATES


D Mario 6/19/2023 10:38:00 PM

grazie mille. i got a satisfactory mark in my exam test today because of this exam dumps. sorry for my english.
ITALY


Bharat Kumar Saraf 10/31/2023 4:36:00 AM

some of the answers are incorrect. need to be reviewed.
HONG KONG


JP 7/13/2023 12:21:00 PM

so far so good
Anonymous


Kiky V 8/8/2023 6:32:00 PM

i am really liking it
Anonymous


trying 7/28/2023 12:37:00 PM

thanks good stuff
UNITED STATES


exampei 10/4/2023 2:40:00 PM

need dump c_tadm_23
Anonymous


Eman Sawalha 6/10/2023 6:18:00 AM

next time i will write a full review
GREECE


johnpaul 11/15/2023 7:55:00 AM

first time using this site
ROMANIA


omiornil@gmail.com 7/25/2023 9:36:00 AM

please sent me oracle 1z0-1105-22 pdf
BANGLADESH