Cisco Implementing Advanced Call Control and Mobility Services (CLASSM) 300-815 Exam Questions in PDF

Free Cisco 300-815 Dumps Questions (page: 20)

A customer has multisite deployments with a globalized dial plan. The customer wants to route PSTN calls via the gateway assigned to each site.
Which two actions will fulfill the requirement? (Choose two.)

  1. Create one global route list for PSTN calls that points to one global PSTN route group.
  2. Create a route group which has all the gateways and associate it to the device pool of every site.
  3. Assign one route group as a local route group in the device pool of the corresponding site.
  4. Create one route group for each site and one global route list for PSTN calls that point to the local route group.
  5. Create a hunt group and assign it to each side route pattern.

Answer(s): A,C


Reference:

https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucm/srnd/8x/uc8x/dialplan.html



An engineer is troubleshooting local ringback on a Cisco SIP gateway. The gateway is not ignoring the SIP 180 response with SDP from the service provider, and the far end device is sending the 180 with SDP to play ringback from the IP address specified in the SDP.
Which configuration change must be made on the gateway to resolve the issue?

  1. Router(config-sip-ua)# no disable-early-media 180
  2. Router(conf-voi-serv)# no disable-early-media 180
  3. Router(conf-voi-serv)# disable-early-media 180
  4. Router(config-sip-ua)# disable-early-media 180

Answer(s): D


Reference:

https://www.cisco.com/en/US/docs/ios/12_3t/voice/command/reference/ vrht_d2_ps5207_TSD_Products_Command_Reference_Chapter.html#wp1452642



An engineer must configure a Cisco UCM hunt list so that calls to users in a line group are routed to the first idle user and then the next.
Which distribution algorithm must be configured to accomplish this task?

  1. broadcast
  2. top down
  3. longest idle time
  4. circular

Answer(s): C


Reference:

https://www.cisco.com/en/US/docs/voice_ip_comm/cucm/admin/4_0_1/ccmcfg/b03lngrp.html



An engineer has temporarily disabled toll fraud prevention for SIP line calls on a Cisco CME12.6x and must enforce security and toll fraud prevention for the SIP line side on Cisco Unified CME. Which configuration must be used to start this process?

  1. voice service voip enable ip address trust list
  2. voice service voip ip address trusted list
  3. voice service voip ip address trusted authenticate
  4. voice service voip enable ip address trust authentication

Answer(s): B


Reference:

https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/admin/configuration/manual/ cmeadm/cmetoll.html



A company has an SRST gateway running an IOS XE image. The company plans to enable the IPv6 addressing companywide. To enable the IPv6 in a unified SRST gateway to support SIP phones, what are two supported supplementary features for an IPv6 fallback scenario? (Choose two.)

  1. three-way conference
  2. secure SIP lines
  3. T.38 fax relay
  4. transcoding
  5. SIP trunk

Answer(s): A,C


Reference:

https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cusrst/admin/sccp_sip_srst/configuration/ guide/SCCP_and_SIP_SRST_Admin_Guide/srst_sip_isr4000.html



Which action is correct with respect to toll fraud prevention configuration in the Cisco Unified Communications Manager Express?

  1. Configure Direct Inward Dial for Incoming ISDN Calls with overlap dialing.
  2. Configure IP Address Trusted Authentication for Incoming VoIP Calls.
  3. Configure the command no ip address trusted authenticate under "voice service voip".
  4. Enable Secondary Dial tone on Analog and Digital FXO Ports.

Answer(s): B


Reference:

https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cucme/admin/configuration/manual/ cmeadm/cmetoll.html#concept_ECC4F4E7ED0F45C594B703EEF34762F2



The administrator sees the voice register pool 1 command in your Cisco UCME configuration.
Which configuration is occurring in this section?

  1. configuration for a single SIP phone
  2. configuration items common for all SIP phones
  3. configuration for a pool of SIP phones (similar to device pool on Cisco UCM)
  4. configuration for SIP registrar service

Answer(s): C


Reference:

https://www.cisco.com/c/en/us/td/docs/voice_ip_comm/cusrst/admin/sccp_sip_srst/configuration/ guide/SCCP_and_SIP_SRST_Admin_Guide/srst_setting_up_using_sip.html



A company wants to use a Cisco phone system without the need for a local generic server. It is maximum 30 phones using a vendor-independent, industry-standard call protocol.
What is the first command that must be entered to add this type of phone when registering a Cisco phone to this device?

  1. ephone 3
  2. voice register pool 3
  3. voice register sip ephone 3
  4. voice register ephone 3

Answer(s): B



Share your comments for Cisco 300-815 exam with other users:

T
TeamOraTech
12/5/2023 9:49:00 AM

very helpful to clear the exam and understand the concept.

C
Curtis
7/12/2023 8:20:00 PM

i think it is great that you are helping people when they need it. thanks.

S
sam
7/17/2023 6:22:00 PM

cannot evaluate yet

N
nutz
7/20/2023 1:54:00 AM

a laptops wireless antenna is most likely located in the bezel of the lid

R
rajesh soni
1/17/2024 6:53:00 AM

good examplae to learn basic

T
Tanya
10/25/2023 7:07:00 AM

this is useful information

N
Nasir Mahmood
12/11/2023 7:32:00 AM

looks usefull

J
Jason
9/30/2023 1:07:00 PM

question 81 should be c.

T
TestPD1
8/10/2023 12:22:00 PM

question 18 : response isnt a ?

A
ally
8/19/2023 5:31:00 PM

plaese add questions

D
DIA
10/7/2023 5:59:00 AM

is dumps still valid ?

A
Annie
7/7/2023 8:33:00 AM

thanks for this

A
arnie
9/17/2023 6:38:00 AM

please upload questions

T
Tanuj Rana
7/22/2023 2:33:00 AM

please upload the question dump for professional machinelearning

F
Future practitioner
8/10/2023 1:26:00 PM

question 4 answer is c. this site shows the correct answer as b. "adopt a consumption model" is clearly a cost optimization design principle. looks like im done using this site to study!!!

A
Ace
8/3/2023 10:37:00 AM

number 52 answer is d

N
Nathan
12/17/2023 12:04:00 PM

just started preparing for my exam , and this site is so much help

C
Corey
12/29/2023 5:06:00 PM

question 35 is incorrect, the correct answer is c, it even states so: explanation: when a vm is infected with ransomware, you should not restore the vm to the infected vm. this is because the ransomware will still be present on the vm, and it will encrypt the files again. you should also not restore the vm to any vm within the companys subscription. this is because the ransomware could spread to other vms in the subscription. the best way to restore a vm that is infected with ransomware is to restore it to a new azure vm. this will ensure that the ransomware is not present on the new vm.

R
Rajender
10/18/2023 3:54:00 AM

i would like to take psm1 exam.

B
Blessious Phiri
8/14/2023 9:53:00 AM

cbd and pdb are key to the database

A
Alkaed
10/19/2022 10:41:00 AM

the purchase and download process is very much streamlined. the xengine application is very nice and user-friendly but there is always room for improvement.

D
Dave Gregen
9/4/2023 3:17:00 PM

please upload p_sapea_2023

S
Sarah
6/13/2023 1:42:00 PM

anyone use this? the question dont seem to follow other formats and terminology i have been studying im getting worried

S
Shuv
10/3/2023 8:19:00 AM

good questions

R
Reb974
8/5/2023 1:44:00 AM

hello are these questions valid for ms-102

M
Mchal
7/20/2023 3:38:00 AM

some questions are wrongly answered but its good nonetheless

S
Sonbir
8/8/2023 1:04:00 PM

how to get system serial number using intune

M
Manju
10/19/2023 1:19:00 PM

is it really helpful to pass the exam

L
LeAnne Hair
8/24/2023 12:47:00 PM

#229 in incorrect - all the customers require an annual review

A
Abdul SK
9/28/2023 11:42:00 PM

kindy upload

A
Aderonke
10/23/2023 12:53:00 PM

fantastic assessment on psm 1

S
SAJI
7/20/2023 2:51:00 AM

56 question correct answer a,b

R
Raj Kumar
10/23/2023 8:52:00 PM

thank you for providing the q bank

P
piyush keshari
7/7/2023 9:46:00 PM

true quesstions

AI Tutor 👋 I’m here to help!