Cisco Troubleshooting Data Center Infrastructure (DCIT) 300-615 Exam Questions in PDF

Free Cisco 300-615 Dumps Questions (page: 9)

Refer to the exhibit.



The VXLAN fabric with BGP EVPN control plane experiences connectivity issues. The hosts in the initial deployed VLAN fail to communicate. The environment is configured as follows:
Private BGP ASN 65122 is used across the whole fabric.
Each leaf node has iBGP peers with each spine node with default values.
Address family L2VPN EVPN is enabled on all leaf and spine BGP speakers.

Which BGP feature is required on the spines for all EVPN routes to be advertised throughout the VXLAN fabric?

  1. ebgp-multihop
  2. allowas-in
  3. route-reflector-client
  4. remove-private-as

Answer(s): C



Refer to the exhibit.



A port channel on a Cisco Nexus 9000 Series Switch uplink experiences connectivity issues. Which configuration resolves the issue?

  1. channel-group 100 mode passive
  2. channel-group 100 force mode on
  3. channel-group 100 mode on
  4. channel-group 100 mode active

Answer(s): D



Refer to the exhibit.



An engineer must restore the connectivity issue between NEXUS-SW-3 and NEXUS-SW-4. The engineer can ping the physical and loopback interfaces used in the underlay from VTEP-1. However, communication between the SVIs in NEXUS-SW-3 and NEXUS-SW-4 fails. Which action resolves the issue?

  1. Change the VNI to VLAN mapping on the NEXUS-SW-2.
  2. Reload the NEXUS-SW-2 to enable the hardware Ethernet store-and-fwd-switching feature.
  3. Manually set the interface MTU to support jumbo frames on the NEXUS-SW-2.
  4. Reconfigure the VXLAN features in the VTEP switches on the NEXUS-SW-2.

Answer(s): A



Refer to the exhibit.



A Cisco VXLAN must use bidirectional PIM so that:

•Spine2 is the active RP for multicast group 225.0.0.0/24.
•Loopback 254 is used as a logical interface for PIM configuration.

After configuration was applied, Spine1 became the active RP for multicast group 225.0.0.0/24 instead of Spine2. Which action resolves the issue?

  1. Delete the bidir keyword from ip pim rp address command on Spine1.
  2. Configure the IP pim ssm range 232.0.0.0/8 on Spine1.
  3. Modify the subnet mask of Loopback 254 to /30 on Spine2.
  4. Change the IP address of Loopback 254 to 10.254.254.254 on Spine2.

Answer(s): D



Refer to the exhibit.



An engineer configures EVPN on Switch-1. but the neighbors fail to exchange EVPN routes. Which action resolves the issue?

  1. Configure neighbor 192.168.0.7 as an L2VPN EVPN route-reflector client.
  2. Activate the IPv4 unicast address family for neighbor 192.168.0.7.
  3. Enable the send extended community option for the L2VPN EVPN address family.
  4. Advertise L2VPN EVPN under the IPv4 unicast address family.

Answer(s): C



Share your comments for Cisco 300-615 exam with other users:

R
Reddy
12/14/2023 2:42:00 AM

these are pretty useful

D
Daisy Delgado
1/9/2023 1:05:00 PM

awesome

A
Atif
6/13/2023 4:09:00 AM

yes please upload

X
Xunil
6/12/2023 3:04:00 PM

great job whoever put this together, for the greater good! thanks!

L
Lakshmi
10/2/2023 5:26:00 AM

just started to view all questions for the exam

R
rani
1/19/2024 11:52:00 AM

helpful material

G
Greg
11/16/2023 6:59:00 AM

hope for the best

H
hi
10/5/2023 4:00:00 AM

will post exam has finished

V
Vmotu
8/24/2023 11:14:00 AM

really correct and good analyze!

H
hicham
5/30/2023 8:57:00 AM

excellent thanks a lot

S
Suman C
7/7/2023 8:13:00 AM

will post once pass the cka exam

R
Ram
11/3/2023 5:10:00 AM

good content

N
Nagendra Pedipina
7/13/2023 2:12:00 AM

q:32 answer has to be option c

T
Tamer Barakat
12/7/2023 5:17:00 PM

nice questions

D
Daryl
8/1/2022 11:33:00 PM

i really like the support team in this website. they are fast in communication and very helpful.

C
Curtis Nakawaki
6/29/2023 9:13:00 PM

a good contemporary exam review

X
x-men
5/23/2023 1:02:00 AM

q23, its an array, isnt it? starts with [ and end with ]. its an array of objects, not object.

A
abuti
7/21/2023 6:24:00 PM

cool very helpfull

K
Krishneel
3/17/2023 10:34:00 AM

i just passed. this exam dumps is the same one from prepaway and examcollection. it has all the real test questions.

R
Regor
12/4/2023 2:01:00 PM

is this a valid prince2 practitioner dumps?

A
asl
9/14/2023 3:59:00 PM

all are relatable questions

S
Siyya
1/19/2024 8:30:00 PM

might help me to prepare for the exam

T
Ted
6/21/2023 11:11:00 PM

just paid and downlaod the 2 exams using the 50% sale discount. so far i was able to download the pdf and the test engine. all looks good.

P
Paul K
11/27/2023 2:28:00 AM

i think it should be a,c. option d goes against the principle of building anything custom unless there are no work arounds available

P
ph
6/16/2023 12:41:00 AM

very legible

S
sephs2001
7/31/2023 10:42:00 PM

is this exam accurate or helpful?

A
ash
7/11/2023 3:00:00 AM

please upload dump, i have exam in 2 days

S
Sneha
8/17/2023 6:29:00 PM

this is useful

S
sachin
12/27/2023 2:45:00 PM

question 232 answer should be perimeter not netowrk layer. wrong answer selected

T
tomAws
7/18/2023 5:05:00 AM

nice questions

R
Rahul
6/11/2023 2:07:00 AM

hi team, could you please provide this dump ?

T
TeamOraTech
12/5/2023 9:49:00 AM

very helpful to clear the exam and understand the concept.

C
Curtis
7/12/2023 8:20:00 PM

i think it is great that you are helping people when they need it. thanks.

S
sam
7/17/2023 6:22:00 PM

cannot evaluate yet

AI Tutor 👋 I’m here to help!