300-510 Exam Questions and Answers | Exam-Dumps (Page: 7)

QUESTION: 31

Refer to the exhibit. While configuring router 2 with all the default values, a network engineer cannot see any route received in router 1. How should the engineer solve the issue?

Modify the IP address or mask of the interface to a valid one
Set up a priority different than 0 in the interface
Modify the router ID to be the interface IP on the serial
Set the network type in S1/0 to point-to-point

Answer(s): A

Reveal Solution Next Question

QUESTION: 32

After an engineer configures BGP in R1, it starts receiving this message:

Which action makes the peering come back up again?

Make a soft reset to the peer
Set up a hello timer higher
Set up a hold-down timer higher
Set up a minimum hold-down timer higher

Answer(s): D

Reveal Solution Next Question

Refer to the exhibit.

An administrator is troubleshooting Internet access issues on a customer’s network. After applying this ISIS configuration to R1, the administrator notices that it fails to redistribute the default route into IS-IS. After checking the connectivity between the ISIS router and the ISP router the engineer confirmed there is Layer 3 connectivity between them. Which action should be taken to correct the problem?

Configure R1 as a Layer 1 router
Add the default-information originate command to the configuration
Configure the default route under any routing protocol other than IS-IS
Associate the default route with a VRF

Answer(s): B

Reveal Solution Next Question

QUESTION: 34

Refer to the exhibit. A network engineer applied configuration on R5 to summarize all OSPF routes, but R4 is still receiving specific routes from R5. The engineer has confirmed that both R5 and R4 routers are configured with correct summarization configuration, but R5 is not sending the summary routes. What action must the engineer take to fix the problem?

Remove summarization configuration on R5 and configure it on R4
Clear link-state database on both R4 and R5 routers for summarization to work
Configure a sham link between R4 and R5 to support summarization within Area 2
Move R4 and R5 in separate areas as now they maintain the same link-state database

Answer(s): D

Reveal Solution Next Question

QUESTION: 35

Refer to the exhibit. Routers within the cluster are not receiving the desired prefixes. What must be done to fix the issue?

Clients in that cluster must have full mesh connectivity between eBGP peers
No client-to-client reflection must be enabled
Clients in that cluster must have full mesh connectivity between iBGP peers
No client-to-client must be disabled

Answer(s): C

Reveal Solution Next Question

Cisco 300-510 Exam (page: 7)
Cisco Implementing Service Provider Advanced Routing Solutions (SPRI)
Updated on: 15-Feb-2026

QUESTION: 31

QUESTION: 32

QUESTION: 33

QUESTION: 34

QUESTION: 35

Cisco 300-510 Exam (page: 7) Cisco Implementing Service Provider Advanced Routing Solutions (SPRI) Updated on: 15-Feb-2026

QUESTION: 31

QUESTION: 32

QUESTION: 33

QUESTION: 34

QUESTION: 35

Cisco 300-510 Exam (page: 7)
Cisco Implementing Service Provider Advanced Routing Solutions (SPRI)
Updated on: 15-Feb-2026