VMware 3V0-41.19 Dumps in PDF and Online - Page: 3

QUESTION: 6

An NSX-T architect is working with a customer who wants to improve performance and future-proof their workloads with a multi-site architecture. A current-state analysis captured this information:

- Latency between sites Is 160ms.

- Bandwidth is 2Gbps.

- The MTU is 1600.
What two VMware design recommendations should the architect recommend to the organization to achieve future-proofing? (Choose two.)

Latency must be less than 150ms.
Bandwidth must be at least 10Gbps.
MTU is recommended to be 9000.
MTU must be at least 1700.
Latency RTT is acceptable.

Answer(s): A,C

Reveal Solution Next Question

QUESTION: 7

An architect is helping an organization with the Logical Design of an NSX-T Data Center solution. This information was gathered during the Assessment Phase:

- There Isn't much budget available for a new off-shore site.

- The new site is decentralized and no communication with the main data center is required.

- The design will need to cater for availability, upgrades, and failure scenarios.
Which three should the architect recommend In their design? (Choose three.)

Collapse the Management/Edge/Compute cluster.
A Shared Edge/Management cluster and one for Compute.
Separate the hosts physical NICs for VSS and N-VDS.
Install a minimum 4 ESXi hosts In the site.
Make all pNICs part of N-VDS and VMKs will be migrated.
Install a minimum of 6 ESXi hosts in the site.

Answer(s): A,B,D

Reveal Solution Next Question

QUESTION: 8

Which three assessment findings are part of a Conceptual Design? (Choose three.)

assumptions
vendor model
justifications
constraints
host names
risks

Answer(s): B,C,D

Reveal Solution Next Question

QUESTION: 9

An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.
This information was gathered during a workshop:

- Some workloads should be moved to a Cloud Provider.
- Extend network's VLAN or VNI across sites on the same broadcast domain.
- Enable VM mobility use cases such as migration and disaster recovery without IP address changes.

- Support 1500 byte MTU between sites.
Which should the architect include in their design?

SSL VPN
Reflexive NAT
L2 VPN
Load Balancer

Answer(s): A

Reveal Solution Next Question

QUESTION: 10

An architect is helping an organization with the Logical Design of an NSX-T Data Center solution. This information was gathered during the Assessment Phase:

- Customer Is concerned with NSX Manager availability.
- 3 cabinets/racks are available in the data center.
- No integration with 3rd party solution is required.
- There is no budget for physical equipment acquisition.
- The 3 cabinets/racks do not share the same L2 domain.
Which three should the architect include in their design to address the customer's concern with NSX Manager availability? (Choose three.)

Use another NSX Manger IP in case an appliance falls.
Deploy 2 cold standby NSX Manager appliances in rack 2/3.
Deploy an NSX Manager Appliance per rack and cluster them.
Use a physical/internal load-balancer with the cluster.
Use separate IP per NSX Manager appliance per rack.
Deploy a single active NSX Manager appliance in rack 1.

Answer(s): B,C,F

Reveal Solution Next Question

VMware Advanced Design NSX-T Data Center 2.4 3V0-41.19 Dumps in PDF

Free VMware 3V0-41.19 Real Questions (page: 3)

QUESTION: 6

QUESTION: 7

QUESTION: 8

QUESTION: 9

QUESTION: 10