FILL BLANKBGP uses a (an) _________ message to withdraw routes. (Enter all letters in lower case.)
Answer(s): A
BGP (Border Gateway Protocol) uses the update message to advertise new routes and withdraw existing routes. When a route is no longer available, BGP sends an update message with the withdrawn routes field, indicating that the route should be removed from the BGP table of the receiving router.Update message is used for both advertising and withdrawing routes in BGP.
Which of the following statements regarding the summary automatic command and BGP route summarization is false?
The summary automatic command in BGP is used to enable automatic summarization, but manual summarization takes precedence over automatic summarization. If you configure manual summarization, it will override the automatic summarization.Automatic summarization does not override manual summarization; it works only when manual summarization is not configured.
When two BGP peers support different Hold Time, they will negotiate to support the shortest Hold Time interval they can support.
In BGP (Border Gateway Protocol), the Hold Time is the maximum time a router waits before declaring a neighbor as dead if no messages (such as Keepalive or Update) are received from the neighbor. The Hold Time is negotiated during the initial BGP session establishment between two peers.If two BGP peers have different Hold Times, they will negotiate and use the shorter of the two Hold Times as the effective Hold Time for that BGP session. This ensures both peers are synchronized in terms of how long they will wait before considering the neighbor down.
In the VRP, by default, the routes imported by BGP will be automatically summarized.
Answer(s): B
In VRP (Virtual Routing Platform), BGP (Border Gateway Protocol) does not automatically summarize routes by default. BGP requires manual configuration for route summarization, meaning that automatic route summarization is disabled by default.If you want to summarize routes in BGP, you must use specific commands like aggregate-address to configure manual summarization.
Which of the following statements regarding Local-Preference in BGP is true?
Answer(s): C
By default, Local-Preference is set to 100 for all BGP routes if no other value is configured. This value can be adjusted based on network requirements to influence the outbound traffic routing.
Which of the following scenarios is not suitable for deploying interface PBR?
Answer(s): D
In this scenario, Policy-Based Routing is not ideal because it is more appropriate to use routing protocols or policy routing at a higher level, like static routing or dynamic routing (e.g., using BGP or OSPF), which allows traffic from different internal network segments to use specific outbound ISP interfaces. PBR is typically not the most scalable or efficient method for this type of scenario, especially when there are multiple outbound paths and policies for each segment.
Which of the following statements regarding characteristics of IP prefixes is false?
An IP prefix filter is used for routing decisions, not for filtering data packets. It filters routing information in routing tables, not the actual data traffic that is sent between devices. Data packet filtering is typically done using ACLs or firewall rules, not IP prefix filters.
A route-policy can have multiple nodes, and each node can have multiple if-match and apply clauses. Which of the following statements are false? (Choose all that apply.)
Answer(s): B,D
The operator between nodes is AND.The operator between nodes in a route-policy is typically OR, not AND. This means that if any node matches, the corresponding apply action will be executed, even if the other nodes do not match.The operator between if-match clauses under a node is OR.The operator between if-match clauses under the same node is AND, not OR. All conditions in the same node must be true for the apply action to be triggered.
Share your comments for Huawei H12-821_V1.0 exam with other users:
very useful to practice
this website is very helpful.
good content
so challenging
17 should be d ,for morequery its scale out
nice question
yes.
good mateial
good practice exam
impressivre qustion
questions seem helpful
question 21 answer is alerts
am preparing for exam
good one thanks
only got thru 5 questions, need more to evaluate
q26 should be b
the aaa triad in information security is authentication, accounting and authorisation so the answer should be d 1, 3 and 5.
need to attend this
these are free brain dumps i understand, how can one get free pdf
provide access
good morning
please upload the ncp-mci 6.5 dumps, really need to practice this one. thanks guys
question 16: https://help.salesforce.com/s/articleview?id=sf.care_console_overview.htm&type=5
yes i m prepared exam
my experience was great with this site as i studied for the ms-900 from here and got 900/1000 on the test. my main focus was on the tutorials which were provided and practice questions. thanks!
great course
very good question
question: 93 which statement is true regarding the result? sales contain 6 columns and values contain 7 columns so c is not right answer.
highly recommend just passed my exam.
great practice! thanks
anyone who wrote this exam recently?
kindly share the dump
could you please upload cfe fraud prevention and deterrence questions? it will be very much helpful.
Keeping this site free takes real effort. We constantly battle automated scraping and unauthorized content copying. A quick account helps us protect the community and keep the site free.
To continue studying for your H12-821_V1.0, please sign in or create a free account.