HPE0-S58 Exam Questions and Answers

QUESTION: 6

Refer to the exhibit.

An integrator needs to add an FCoE connection to the server profile, but the FCoE connection type is not available. What is the likely cause of this issue?

FCoE capable interconnect modules are not installed in the Synergy frame
Defined FCoE network is not associated with a SAN or does not have VLAN Id defined
A FCoE connection is not available, as there is no LIG configured for FCoE connectivity
The FCoE connection has not been added as a Fibre Channel connection within a server profile

Answer(s): D

Reveal Solution Next Question

An integrator is installing three Synergy frames in different locations for a customer. As part of the installation, the customer requests a single monitoring dashboard that shows the current hardware status, warranty status, and open support cases of all three frames.
Which configuration steps must the integrator perform to provide the customer with this functionality?

Enable Remote Support and Insight Online Integration in the Composer UI
Install Insight Remote Support Advanced, and integrate it with HPE Global Dashboard
Configure OneView with iLO Amplifier pack
Activate iLO Federation on all installed compute nodes

Answer(s): C

Reveal Solution Next Question

QUESTION: 8

What are valid uses for an IPv4 address pool when configuring an HPE Synergy solution? (Choose two.)

assignment of IP addresses for NICs in an operating system
assignment of IP addresses for Composer appliances
assignment of IP addresses for PXE booting to a deployment server
assignment of IP addresses for interconnect modules
assignment of IP addresses for iLOs

Answer(s): D,E

Reference:

https://techlibrary.hpe.com/docs/synergy/shared/setup_overview/index.html

Reveal Solution Next Question

QUESTION: 9

HOTSPOT
A customer has the following HPE Synergy solution:

-three Synergy frames
-two HPE Virtual Connect SE 32Gb Fibre Channel (FC) modules in each time
-two HPE Virtual Connect SE 40GB F8 modules
-four HPE Synergy 10Gb Interconnect Link Modules
-
Click the menu option the integrator should use to add more uplinks ports from HPE Virtual Connect SE 32 Gb FC modules to SAN uplink set.

Hot Area:
Exhibit A:

Exhibit B: