What are three characteristics of VLAN translation?
Answer(s): A,B,E
VLAN translation is not supported on MC-LAG port channel interfaces (A): This is a restriction commonly seen in network configurations involving Multi-Chassis Link Aggregation (MC-LAG) where VLAN translation capabilities are not applied.Trunk or access ports can be configured as members of any VLANs that are not used as an SVLAN (B):This ensures that the VLAN configuration on trunk or access ports is flexible and does not overlap with Service VLANs (SVLANs).SVLAN configuration for both Q-in-Q VLAN tunneling and VLAN translation is possible on the same interface (E): This allows for complex VLAN tagging and translation configurations to be applied to the same interface, supporting advanced networking scenarios.
Dell Technologies SONiC documentationDell Networking Configuration Guide
Refer to the exhibit.Which three actions can a customer take to change interface Eth1/10 to operate in access mode for VLAN 40?
Answer(s): A,D,E
Configure the access mode for the switch port (A): This involves setting the switch port to operate in access mode.Remove the current access VLAN configuration (D): Before changing the VLAN, the current configuration must be cleared.Enter it into the relevant interface (E): Apply the new configuration to the specific interface, Eth1/10.Steps:interface Ethernet no switchport access vlan <current VLAN> (Remove current VLAN)switchport mode access switchport access vlan 40
How many ports are in each port-group on the S5200 series switches?
Answer(s): C
Each port-group on the S5200 series switches consists of 4 ports. This grouping allows for efficient management and configuration of the switch ports in sets.
Dell S5200 Series Switches DocumentationDell Technologies InfoHub
Refer to the exhibit.What is the purpose of the static route?
Answer(s): A
The static route shown in the exhibit S* 12.0.0.0/16 via 192.168.45.254 Vlan45 is used to provide a route to the 12.0.0.0 network. This static route directs traffic destined for the 12.0.0.0/16 network through the gateway at 192.168.45.254, which is associated with VLAN 45. This configuration is typically used to ensure that traffic can reach a specific network via a defined path.
Dell Technologies SONiC Routing GuideDell Networking Configuration Guide
An administrator for a service provider uses this command on a switch:What is the result of running the command?
The command interface vxlan vtep-stacking followed by map vni 10010 vlan 100 maps the VLAN traffic that an SVLAN identifies to a VNI on a VTEP. In this context, SVLAN (Service VLAN) is being mapped to a VXLAN Network Identifier (VNI) for encapsulation and transport across the VXLAN tunnel.
Dell Technologies SONiC documentationVXLAN Configuration Guide
Share your comments for Dell D-SNC-DY-00 exam with other users:
very g inood
q35 should be a
sap c_ts450_2021
nice questions
ecellent materil for unserstanding
good so far
this is way too informative
very helpfull
q.189 - answers are incorrect.
awesome job in getting these questions
i cant find aws certified practitioner clf-c01 exam in aws website but i found aws certified practitioner clf-c02 exam. can everyone please verify the difference between the two clf-c01 and clf-c02? thank you
grazie mille. i got a satisfactory mark in my exam test today because of this exam dumps. sorry for my english.
some of the answers are incorrect. need to be reviewed.
so far so good
i am really liking it
thanks good stuff
need dump c_tadm_23
next time i will write a full review
first time using this site
please sent me oracle 1z0-1105-22 pdf
very helpful
good info about oml
very useful to practice
this website is very helpful.
good content
so challenging
17 should be d ,for morequery its scale out
nice question
yes.
good mateial
good practice exam
impressivre qustion
questions seem helpful