Amazon
Avaya
Cisco
CompTIA
CrowdStrike
EC-Council
EXIN
Fortinet
Google
ISC
ISC2
ITIL
Juniper
Microsoft
NVIDIA
Okta
Palo Alto Networks
Salesforce
All Vendors
  1. Home
  2. Dell
  3. D-PST-OE-23

Dell D-PST-OE-23 Exam (page: 1)
Dell PowerStore Operate 2023
Updated on: 12-Feb-2026

Viewing Page 1 of 13
D-PST-OE-23 PDF 96 Questions

What describes Dell PowerStore X front-end cabling?

  1. Uses internal VMware virtual switching and does not require a management network
  2. Storage and management use the same LACP bonded cable connection
  3. Uses VLTi data switch interconnectivity to support vMotion networks
  4. Management and discovery use the same cables and connections as storage

Answer(s): D

Explanation:

"For PowerStore T model appliances, the individual ports within the system bond could be running in active/active mode or active/passive mode. This state depends on whether Link Aggregation Control Protocol (LACP) has been configured on the network switches. To ensure best resiliency and network performance, it is recommended to enable LACP on the network. For more information about configuring LACP for a PowerStore T model appliance, see the document PowerStore Guide for PowerStore T Models on the PowerStore Info Hub. For PowerStore X model appliances, there is no system bond and no LACP configuration is needed because the link aggregation and failover is handled by the virtual switches within the VMware hypervisor. "



Through which network do external hosts connect to the cluster for data access?

  1. Management
  2. ICM
  3. ICD
  4. Storage

Answer(s): D

Explanation:

https://topics-cdn.dell.com/pdf/pwrstr-hcg_en-us.pdf



A Storage Administrator is adding an appliance into an existing Dell PowerStore T cluster.

What is different about the management network configuration for the new appliance compared to configuring an initial appliance for the cluster?

  1. All the needed management IP addresses for the new appliance must be pre-configured on the cluster
  2. Additional appliance does not require a cluster management IP address
  3. Additional appliance inherits all its management IPs from the existing appliance
  4. All the needed management IP addresses for the new appliance are auto-generated by the cluster

Answer(s): A

Explanation:

Each appliance must have Management and Storage networks configured. Management networks connect the cluster to management services such as DNS, NTP, and vCenter. The management network also enables external clients to access the cluster. The Storage network connects the cluster to an existing storage network or establishes a new network within the cluster. It also enables external clients to access the storage in the cluster. Both the Management and Storage networks require at least three IP addresses



What describes the power requirements for Dell PowerStore?

  1. Lower model numbered systems require less AC line current than higher model numbered systems
  2. T models require less total power than X models
  3. X models require less total power than T models
  4. Lower model numbered systems require less input voltage (VAC) than higher model numbered systems

Answer(s): A

Explanation:

Maximum input power 240 VAC ± 10%, single phase For 100-120V, a customer-supplied step-up transformer is required AC Line Current (operating maximum at 200 VAC) 8.1 A 8.1 A 9.0 A 9.0 A 9.3 A 10.4 A https://www.dell.com/support/manuals/en-us/powerstore-5000/pwrstr-plang/power- requirements-for-powerstore-x-model-and-powerstore-t-model?guid=guid-21e142df-e22c-4bbc- 8978-7c6124753654&lang=en-us


Reference:

https://www.dell.com/support/manuals/pk/en/pkbsd1/powerstore/pwrstr-plang/power-

requirements?guid=guid-21e142df-e22c-4bbc-8978-7c6124753654&lang=en-us



What is the last step when adding a drive to a Dell PowerStore system?

  1. Verify the new drive is seen
  2. Add the drive to the pool
  3. Backup the keystore
  4. Zero the drive

Answer(s): C


Reference:

https://www.dell.com/support/manuals/pk/en/pkbsd1/powerstore-9000t/pwrstr- isg/install-a-25- drive?guid=guid-bddae51e-a561-4e84-bc0a-c2e99a43f033&lang=en-us



Refer to the exhibit.



A Storage Administrator is troubleshooting a Dell PowerStore T hardware issue. They observe that the base enclosure LED circled is blue.
What does this indicate?

  1. Base enclosure hardware is operating normally
  2. Base enclosure has a component hardware fault
  3. Cluster has only a single appliance
  4. Appliance has a node in service mode

Answer(s): A


Reference:

https://www.dell.com/support/manuals/pk/en/pkbsd1/powerstore-9000t/pwrstr- isg/embedded- module-leds?guid=guid-bc07892c-75cf-43b6-8f17-8a4c49001aeb&lang=en-us



A Storage Administrator needs to connect through SSH to run svc commands. How is the SSH session configured?

  1. Appliance IP address using port 22
  2. NAS server IP address using port 26
  3. NAS server IP address using port 22
  4. Appliance IP address using port 26

Answer(s): A



Which port is used to SSH from one Dell PowerStore appliance to another?

  1. 22
  2. 26
  3. 443
  4. 21

Answer(s): B


Reference:

https://topics-cdn.dell.com/pdf/pwrstr-scg_en-us.pdf



Viewing Page 1 of 13



Share your comments for Dell D-PST-OE-23 exam with other users:

CiscoStudent 11/15/2023 5:29:00 AM

in question 272 the right answer states that an autonomous acces point is "configured and managed by the wlc" but this is not what i have learned in my ccna course. is this a mistake? i understand that lightweight aps are managed by wlc while autonomous work as standalones on the wlan.
Anonymous


pankaj 9/28/2023 4:36:00 AM

it was helpful
Anonymous


User123 10/8/2023 9:59:00 AM

good question
UNITED STATES


vinay 9/4/2023 10:23:00 AM

really nice
Anonymous


Usman 8/28/2023 10:07:00 AM

please i need dumps for isc2 cybersecuity
Anonymous


Q44 7/30/2023 11:50:00 AM

ans is coldline i think
UNITED STATES


Anuj 12/21/2023 1:30:00 PM

very helpful
Anonymous


Giri 9/13/2023 10:31:00 PM

can you please provide dumps so that it helps me more
UNITED STATES


Aaron 2/8/2023 12:10:00 AM

thank you for providing me with the updated question and answers. this version has all the questions from the exam. i just saw them in my exam this morning. i passed my exam today.
SOUTH AFRICA


Sarwar 12/21/2023 4:54:00 PM

how i can see exam questions?
CANADA


Chengchaone 9/11/2023 10:22:00 AM

can you please upload please?
Anonymous


Mouli 9/2/2023 7:02:00 AM

question 75: option c is correct answer
Anonymous


JugHead 9/27/2023 2:40:00 PM

please add this exam
Anonymous


sushant 6/28/2023 4:38:00 AM

please upoad
EUROPEAN UNION


John 8/7/2023 12:09:00 AM

has anyone recently attended safe 6.0 certification? is it the samq question from here.
Anonymous


Blessious Phiri 8/14/2023 3:49:00 PM

expository experience
Anonymous


concerned citizen 12/29/2023 11:31:00 AM

52 should be b&c. controller failure has nothing to do with this type of issue. degraded state tells us its a raid issue, and if the os is missing then the bootable device isnt found. the only other consideration could be data loss but thats somewhat broad whereas b&c show understanding of the specific issues the question is asking about.
UNITED STATES


deedee 12/23/2023 5:10:00 PM

great help!!!
UNITED STATES


Samir 8/1/2023 3:07:00 PM

very useful tools
UNITED STATES


Saeed 11/7/2023 3:14:00 AM

looks a good platform to prepare az-104
Anonymous


Matiullah 6/24/2023 7:37:00 AM

want to pass the exam
Anonymous


SN 9/5/2023 2:25:00 PM

good resource
UNITED STATES


Zoubeyr 9/8/2023 5:56:00 AM

question 11 : d
FRANCE


User 8/29/2023 3:24:00 AM

only the free dumps will be enough for pass, or have to purchase the premium one. please suggest.
Anonymous


CW 7/6/2023 7:37:00 PM

good questions. thanks.
Anonymous


Farooqi 11/21/2023 1:37:00 AM

good for practice.
INDIA


Isaac 10/28/2023 2:30:00 PM

great case study
UNITED STATES


Malviya 2/3/2023 9:10:00 AM

the questions in this exam dumps is valid. i passed my test last monday. i only whish they had their pricing in inr instead of usd. but it is still worth it.
INDIA


rsmyth 5/18/2023 12:44:00 PM

q40 the answer is not d, why are you giving incorrect answers? snapshot consolidation is used to merge the snapshot delta disk files to the vm base disk
IRELAND


Keny 6/23/2023 9:00:00 PM

thanks, very relevant
PERU


Muhammad Rawish Siddiqui 11/29/2023 12:14:00 PM

wrong answer. it is true not false.
SAUDI ARABIA


Josh 7/10/2023 1:54:00 PM

please i need the mo-100 questions
Anonymous


VINNY 6/2/2023 11:59:00 AM

very good use full
Anonymous


Andy 12/6/2023 5:56:00 AM

very valid questions
Anonymous