CompTIA RC0-903 Exam (page: 10)
CompTIA A+ Recertification Exam for Continuing Education
Updated on: 15-Feb-2026

Viewing Page 10 of 53

A technician is troubleshooting a desktop that is having intermittent issues with locking up and system errors. The technician suspects that the problem might be that not enough power is getting to the motherboard. Which of the following tools would a technician use to determine if the hypothesis is correct?

  1. POST card
  2. Loopback plug
  3. Multimeter
  4. Cable tester

Answer(s): C



The OSD of a monitor indicates the proper video source is selected, but no image is displayed. Which of the following issues are the MOST likely reasons? (Select TWO).

  1. The source cable is disconnected
  2. The monitor’s brightness is set too low
  3. The backlighting of the monitor is faulty
  4. The monitor’s contrast is set too high
  5. No device is sending source video

Answer(s): A,E



A technician is working on a server with high latency on the mapped network drive. Upon entry into the server room, the technician suspects an issue with one of the drives in the array. Which of the following would the technician do to resolve the problem?

  1. Reseat the drive cable in the array.
  2. Replace the RAID controller.
  3. Replace the faulty drive in the array.
  4. Reinstall the RAID drivers.

Answer(s): C



A user, Ann, reports that her company laptop cannot pick up a wireless connection in certain areas of a building. However, users working on their laptops in the common areas have Internet connectivity. Which of the following is the MOST likely cause?

  1. Weak RF signals
  2. Out of date Ethernet driver
  3. Enabled MAC filtering
  4. Duplicate IP addresses

Answer(s): A



After receiving a call from an executive, a technician walks into a meeting room to find that the projector is not showing the screen of the executive’s laptop. The projector shows a
message that reads “No video signal”. Which of the following is the FIRST thing that the technician should do?

  1. Adjust the laptop's screen brightness
  2. Replace the projector's bulb
  3. Verify the VGA cable is connected
  4. Ensure secondary display is enabled

Answer(s): C



Viewing Page 10 of 53



Share your comments for CompTIA RC0-903 exam with other users:

Sasuke 7/11/2023 10:30:00 PM

please upload the dump. thanks very much !!
Anonymous


V 7/4/2023 8:57:00 AM

good questions
UNITED STATES


TTB 8/22/2023 5:30:00 AM

hi, could you please update the latest dump version
Anonymous


T 7/28/2023 9:06:00 PM

this question is keep repeat : you are developing a sales application that will contain several azure cloud services and handle different components of a transaction. different cloud services will process customer orders, billing, payment, inventory, and shipping. you need to recommend a solution to enable the cloud services to asynchronously communicate transaction information by using xml messages. what should you include in the recommendation?
NEW ZEALAND


Gurgaon 9/28/2023 4:35:00 AM

great questions
UNITED STATES


wasif 10/11/2023 2:22:00 AM

its realy good
UNITED ARAB EMIRATES


Shubhra Rathi 8/26/2023 1:12:00 PM

oracle 1z0-1059-22 dumps
Anonymous


Leo 7/29/2023 8:48:00 AM

please share me the pdf..
INDIA


AbedRabbou Alaqabna 12/18/2023 3:10:00 AM

q50: which two functions can be used by an end user when pivoting an interactive report? the correct answer is a, c because we do not have rank in the function pivoting you can check in the apex app
GREECE


Rohan Limaye 12/30/2023 8:52:00 AM

best to practice
Anonymous


Aparajeeta 10/13/2023 2:42:00 PM

so far it is good
Anonymous


Vgf 7/20/2023 3:59:00 PM

please provide me the dump
Anonymous


Deno 10/25/2023 1:14:00 AM

i failed the cisa exam today. but i have found all the questions that were on the exam to be on this site.
Anonymous


CiscoStudent 11/15/2023 5:29:00 AM

in question 272 the right answer states that an autonomous acces point is "configured and managed by the wlc" but this is not what i have learned in my ccna course. is this a mistake? i understand that lightweight aps are managed by wlc while autonomous work as standalones on the wlan.
Anonymous


pankaj 9/28/2023 4:36:00 AM

it was helpful
Anonymous


User123 10/8/2023 9:59:00 AM

good question
UNITED STATES


vinay 9/4/2023 10:23:00 AM

really nice
Anonymous


Usman 8/28/2023 10:07:00 AM

please i need dumps for isc2 cybersecuity
Anonymous


Q44 7/30/2023 11:50:00 AM

ans is coldline i think
UNITED STATES


Anuj 12/21/2023 1:30:00 PM

very helpful
Anonymous


Giri 9/13/2023 10:31:00 PM

can you please provide dumps so that it helps me more
UNITED STATES


Aaron 2/8/2023 12:10:00 AM

thank you for providing me with the updated question and answers. this version has all the questions from the exam. i just saw them in my exam this morning. i passed my exam today.
SOUTH AFRICA


Sarwar 12/21/2023 4:54:00 PM

how i can see exam questions?
CANADA


Chengchaone 9/11/2023 10:22:00 AM

can you please upload please?
Anonymous


Mouli 9/2/2023 7:02:00 AM

question 75: option c is correct answer
Anonymous


JugHead 9/27/2023 2:40:00 PM

please add this exam
Anonymous


sushant 6/28/2023 4:38:00 AM

please upoad
EUROPEAN UNION


John 8/7/2023 12:09:00 AM

has anyone recently attended safe 6.0 certification? is it the samq question from here.
Anonymous


Blessious Phiri 8/14/2023 3:49:00 PM

expository experience
Anonymous


concerned citizen 12/29/2023 11:31:00 AM

52 should be b&c. controller failure has nothing to do with this type of issue. degraded state tells us its a raid issue, and if the os is missing then the bootable device isnt found. the only other consideration could be data loss but thats somewhat broad whereas b&c show understanding of the specific issues the question is asking about.
UNITED STATES


deedee 12/23/2023 5:10:00 PM

great help!!!
UNITED STATES


Samir 8/1/2023 3:07:00 PM

very useful tools
UNITED STATES


Saeed 11/7/2023 3:14:00 AM

looks a good platform to prepare az-104
Anonymous


Matiullah 6/24/2023 7:37:00 AM

want to pass the exam
Anonymous