CompTIA Network+ N10-008 Dumps in PDF

Free CompTIA N10-008 Real Questions (page: 11)

An IT manager needs to connect ten sites in a mesh network. Each needs to be secured with reduced provisioning time.
Which of the following technologies will best meet this requirement?

  1. SD-WAN
  2. VXLAN
  3. VPN
  4. NFV

Answer(s): A



Which of the following is most likely responsible for the security and handling of personal data in Europe?

  1. GDPR
  2. SCADA
  3. SAML
  4. PCI DSS

Answer(s): A



An organization has a security requirement that all network connections can be traced back to a user. A network administrator needs to identify a solution to implement on the wireless network.
Which of the following is the best solution?

  1. Implementing enterprise authentication
  2. Requiring the use of PSKs
  3. Configuring a captive portal for users
  4. Enforcing wired equivalent protection

Answer(s): A



A customer is adding fiber connectivity between adjacent buildings. A technician terminates the multimode cable to the fiber patch panel. After the technician connects the fiber patch cable, the indicator light does not tum on.
Which of the following should a technician try first to troubleshoot this issue?

  1. Reverse the fibers.
  2. Reterminate the fibers.
  3. Verify the fiber size.
  4. Examine the cable runs for visual faults.

Answer(s): A



Users cannot connect to an internal website with an IP address 10.249.3.76. A network administrator runs a command and receives the following output:



Which of the following command-line tools is the network administrator using?

  1. tracert
  2. netstat
  3. tcpdump
  4. nmap

Answer(s): A



After running a Cat 8 cable using passthrough plugs, an electrician notices that connected cables are experiencing a lot of cross talk.
Which of the following troubleshooting steps should the electrician take first?

  1. Inspect the connectors for any wires that are touching or exposed.
  2. Restore default settings on the connected devices.
  3. Terminate the connections again.
  4. Check for radio frequency interference in the area.

Answer(s): A



A technician is troubleshooting a user's laptop that is unable to connect to a corporate server. The technician thinks the issue pertains to routing.
Which of the following commands should the technician use to identify the issue?

  1. tcpdump
  2. dig
  3. tracert
  4. arp

Answer(s): C



After installing a series of Cat 8 keystones, a data center architect notices higher than normal interference during tests.
Which of the following steps should the architect take to troubleshoot the issue?

  1. Check to see if the end connections were wrapped in copper tape before terminating.
  2. Use passthrough modular crimping plugs instead of traditional crimping plugs.
  3. Connect the RX/TX wires to different pins.
  4. Run a speed test on a device that can only achieve 100Mbps speeds.

Answer(s): A



Share your comments for CompTIA N10-008 exam with other users:

T
Timi
8/19/2023 5:30:00 PM

my first attempt

V
VoiceofMidnight
12/29/2023 4:48:00 PM

i passed!! ...but barely! got 728, but needed 720 to pass. the exam hit me with labs right out of the gate! then it went to multiple choice. protip: study the labs!

N
Nathan
12/17/2023 12:04:00 PM

just started preparing for my exam , and this site is so much help

A
Abwoch Peter
7/4/2023 3:08:00 AM

am preparing for exam

N
Nhlanhla
12/13/2023 5:26:00 AM

just passed the exam on my first try using these dumps.

D
DaveG
12/15/2023 4:50:00 PM

just passed my exam yesterday on my first attempt. these dumps were extremely helpful in passing first time. the questions were very, very similar to these questions!

P
philly
9/18/2023 2:40:00 PM

its my first time exam

A
alma
8/25/2023 1:20:00 PM

just started preparing for the exam

A
Abduraimov
4/19/2023 12:43:00 AM

preparing for this exam is overwhelming. you cannot pass without the help of these exam dumps.

V
VoiceofMidnight
12/17/2023 4:07:00 PM

Delayed the exam until December 29th.

AI Tutor 👋 I’m here to help!