Company XYZ is planning to deploy primary and secondary (disaster recovery) data center sites. Each of these sites will have redundant SAN fabrics and data protection is expected between the data center sites. The sites are 100 miles (160 km) apart and target RPO/RTO are 3 hrs and 24 hrs, respectively. Which two considerations must Company XYZ bear in mind when deploying replication in their scenario? (Choose two.)
Answer(s): B,D
An architect receives a business requirement from a CTO that states the RTO and RPO for a new system should be as close as possible to zero. Which replication method and data center technology should be used?
Answer(s): A
-Synchronous replication ensures that the data on the secondary site is always up-to-date with the data on the primary site. This means that there is no RPO, as no data will be lost in the event of a failure.-Geographically dispersed dual data centers means that the secondary site is located in a different geographical location from the primary site. This helps to protect against natural disasters and other events that could affect both sites.-MPLS (Multiprotocol Label Switching) is a high-performance network technology that can be used to replicate data between geographically dispersed sites.The other options are not as suitable for this scenario.-Asynchronous replication does not guarantee that the data on the secondary site is always up-to-date with the data on the primary site. This means that there is an RPO, and some data could be lost in the event of a failure.-Metro Ethernet is a less reliable network technology than MPLS. This means that it is more likely to experience outages, which could lead to data loss.-CWDM (Coarse Wavelength Division Multiplexing) and DWDM (Dense Wavelength Division Multiplexing) are both optical networking technologies that can be used to transmit data over long distances. However, they are not as reliable as MPLS, and they can be more expensive.
What are two primary design constraints when a robust infrastructure solution is created? (Choose two.)
Answer(s): C,E
Solutions is already created, nothing mentioned about new technologies (staff experience is out), I hope it's not year 2023 (no components issue). Cost and time to build the solution.Good link to read.
https://community.cisco.com/legacyfs/online/ccde_9781587144615_chapter1.pdf
Which network management framework can be used to develop a network architecture that contains business requirements analysis, gap analysis, and network diagrams as artifacts to be used for design and implementation later?
Answer(s): C
The Open Group Architecture Framework, or TOGAF, is intended to serve as a standard for developing and implementing very large computer systems. TOGAF is used by 80% of Global 50 companies today. TOGAF® is used to help organizations design an IT infrastructure that is adapted to meet their requirements.
Which two types of planning approaches are used to develop business-driven network designs and to facilitate the design decisions? (Choose two.)
Answer(s): A,C
The two types of planning approaches that are used to develop business-driven network designs and to facilitate the design decisions are strategic planning approach and tactical planning approach.-Strategic planning approach is a long-term planning approach that focuses on the overall goals and objectives of the organization. This approach is used to ensure that the network design is aligned with the organization's business strategy.-Tactical planning approach is a short-term planning approach that focuses on the specific needs of the organization. This approach is used to ensure that the network design can meet the current and future needs of the organization.The other options are not as suitable for this purpose.-Business optimization approach is a more general approach to planning that can be used for any type of business. It is not specifically focused on network design.-Modular approach is a way of designing networks that uses pre-defined modules. This approach can be used to speed up the design process, but it can also make it difficult to adapt the network to changing needs.-Cost optimization approach is a way of designing networks that focuses on minimizing the cost of the network. This approach can be used to save money, but it can also lead to a network that is not as reliable or secure.
https://community.cisco.com/legacyfs/online/ccde_9781587144615_chapter1.pdf page 18
Share your comments for Cisco 400-007 exam with other users:
q.119 - the correct answer is b - they are not captured in an update set as theyre data.
good matter
please upload c_sacp_2308
please upload the dump. thanks very much !!
good questions
hi, could you please update the latest dump version
this question is keep repeat : you are developing a sales application that will contain several azure cloud services and handle different components of a transaction. different cloud services will process customer orders, billing, payment, inventory, and shipping. you need to recommend a solution to enable the cloud services to asynchronously communicate transaction information by using xml messages. what should you include in the recommendation?
great questions
its realy good
oracle 1z0-1059-22 dumps
please share me the pdf..
q50: which two functions can be used by an end user when pivoting an interactive report? the correct answer is a, c because we do not have rank in the function pivoting you can check in the apex app
best to practice
so far it is good
please provide me the dump
i failed the cisa exam today. but i have found all the questions that were on the exam to be on this site.
in question 272 the right answer states that an autonomous acces point is "configured and managed by the wlc" but this is not what i have learned in my ccna course. is this a mistake? i understand that lightweight aps are managed by wlc while autonomous work as standalones on the wlan.
it was helpful
good question
really nice
please i need dumps for isc2 cybersecuity
ans is coldline i think
very helpful
can you please provide dumps so that it helps me more
thank you for providing me with the updated question and answers. this version has all the questions from the exam. i just saw them in my exam this morning. i passed my exam today.
how i can see exam questions?
can you please upload please?
question 75: option c is correct answer
please add this exam
please upoad
has anyone recently attended safe 6.0 certification? is it the samq question from here.
expository experience
52 should be b&c. controller failure has nothing to do with this type of issue. degraded state tells us its a raid issue, and if the os is missing then the bootable device isnt found. the only other consideration could be data loss but thats somewhat broad whereas b&c show understanding of the specific issues the question is asking about.
great help!!!