Cisco 300-630 Exam (page: 3)
Cisco Implementing Application Centric Infrastructure - Advanced
Updated on: 12-Feb-2026

Viewing Page 3 of 17

Refer to the exhibit. An engineer is configuring a vSwitch policy in the existing Cisco ACI fabric. The requirement is for the Cisco ACI leaf to learn individual MAC addresses from the same physical port. Which vSwitch policy configuration mode must be enabled to meet this requirement?

  1. MAC pinning
  2. MAC binding
  3. LACP passive
  4. LACP active

Answer(s): A



A host that is connected to a Cisco ACI fabric leaf switch sends an ARP request. Which transmission method does the ingress switch use to send the ARP requests?

  1. anycast
  2. broadcast
  3. multicast
  4. unicast

Answer(s): D


Reference:

https://www.cisco.com/c/en/us/td/docs/dcn/whitepapers/cisco-application-centric-infrastructure-design-guide.html



An engineer is implementing the Cisco ACI fabric but is experiencing loops detected from endpoints. When the issue was investigated, it was discovered that the packets are received with the same source IP address but from different leaf switch ports. The engineer must prevent the issue from happening in the future and make sure that the port is brought back up if it was disabled due to the loop discovered. Which set of actions must be taken to meet these requirements?

  1. Enable the enforce endpoint check and set the Rouge EP detection interval
  2. Enable the rogue endpoint and set the Error Disabled Recovery Policy
  3. Enable the remote endpoint limit and set the Interface override
  4. Enable reverse path forwarding and set the Hold Interval

Answer(s): B



An engineer implements the Cisco ACI solution and needs to confirm that the leaf switch correctly learns the remote endpoint MAC. Which information must be included in the VXLAN packet that is received from the Cisco ACI spine for the Cisco ACI leaf to learn MAC as a remote endpoint?

  1. VRF
  2. application profile
  3. bridge domain
  4. EPG

Answer(s): C


Reference:

https://www.cisco.com/c/en/us/solutions/collateral/data-center-virtualization/application-centric-infrastructure/white-paper-c11-739989.html



Which action reduces the impact on workload when migrating from the existing Cisco NX-OS VXLAN network infrastructure to the Cisco ACI fabric?

  1. Disable bridge domain unicast routing while a default gateway is in VXLAN infrastructure
  2. Set the default gateway in the Cisco ACI and VXLAN fabrics
  3. Use ACI spines for the Cisco ACI and VXLAN fabrics
  4. Configure vPC between the standalone Nexus and the Cisco ACI leaf

Answer(s): B


Reference:

https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/migration_guides/migrating_existing_networks_to_aci.html#_Toc27467765



Viewing Page 3 of 17



Share your comments for Cisco 300-630 exam with other users:

Abduraimov 4/19/2023 12:43:00 AM

preparing for this exam is overwhelming. you cannot pass without the help of these exam dumps.
UNITED KINGDOM


Puneeth 10/5/2023 2:06:00 AM

new to this site but i feel it is good
EUROPEAN UNION


Ashok Kumar 1/2/2024 6:53:00 AM

the correct answer to q8 is b. explanation since the mule app has a dependency, it is necessary to include project modules and dependencies to make sure the app will run successfully on the runtime on any other machine. source code of the component that the mule app is dependent of does not need to be included in the exported jar file, because the source code is not being used while executing an app. compiled code is being used instead.
Anonymous


Merry 7/30/2023 6:57:00 AM

good questions
Anonymous


VoiceofMidnight 12/17/2023 4:07:00 PM

Delayed the exam until December 29th.
UNITED STATES


Umar Ali 8/29/2023 2:59:00 PM

A and D are True
Anonymous


vel 8/28/2023 9:17:09 AM

good one with explanation
Anonymous


Gurdeep 1/18/2024 4:00:15 PM

This is one of the most useful study guides I have ever used.
CANADA