Cisco Implementing Application Centric Infrastructure (DCACI) 300-620 Dumps in PDF

Free Cisco 300-620 Real Questions (page: 14)

Which resolution immediacy setting allows a policy to be downloaded to the Cisco ACI leaf switch software regardless of CDP/LLDP neighborship?

  1. Expedite
  2. Immediate
  3. Pre-Provision
  4. On Demand

Answer(s): C

Explanation:

The Pre-Provision resolution mode causes the policy to be sent straight to the leaf's software database immediately - without waiting for CDP/LLDP discovery - whereas On-Demand holds off until a neighbor is detected.



Refer to the exhibit.





A Cisco ACI fabric has four access policy groups. The VPC reciprocal protection group has been defined. The N9K1 trunks VLANs 10-20 to ACI leaf switches. Which policy group must be associated with Eth1/1 and Eth1/2 to complete the deployment?

  1. PEGRKAL12_PolGrp
  2. PEGRMET12_PolGrp
  3. PEGRKIF11_PolGrp
  4. PEGRPAL11_PolGrp

Answer(s): B

Explanation:

The fabric links from N9K1 to two separate ACI leaves form a VPC-style multi-node port channel. You must use the policy group with lagT = node (PEGRMET12_PolGrp) so that both Eth1/1 and Eth1/2 are treated as one portchannel across leaf1 and leaf2.



Which function does spine switch perform in the Cisco ACI fabric?

  1. It connects to classic Ethernet devices in the multitier topology.
  2. It decapsulates VXLAN packets received from leaf switches.
  3. It stores all the entries of endpoints-to-VTEP mapping.
  4. It bridges tenant packets for applying network policies.

Answer(s): B

Explanation:

In an ACI fabric the spine's role is purely L3 - it terminates the VXLANGPE tunnels from the leaves, removes the outer VXLAN header (decapsulation), routes the packet to the correct leaf, then re-encapsulates it for onward delivery. The leaf switches handle bridging and policy enforcement, and neither store the full endpoint- to-VTEP mapping nor connect directly to traditional Ethernet devices.



Refer to the exhibit.



A company deployed Cisco ACI and plans to migrate the first servers to the Cisco ACI fabric. The current network setup experiences a small number of silent hosts. What is the Cisco recommended bridge domain configuration to support the network topology presented?

  1. Unicast Routing: Disabled
    L2 Unknown Unicast: Flood
  2. Unicast Routing: Enabled
    L2 Unknown Unicast: Hw Proxy
  3. ARP Flooding: Enabled
    Multi Destination Flooding: Flood in BD
  4. ARP Flooding: Disabled
    L3 Unknown Multicast Flooding: Flood

Answer(s): B

Explanation:

When you extend an existing L3-switched network into ACI and keep the original SVI as the gateway, enabling Unicast Routing on the bridge domain lets the fabric advertise its host routes back to that SVI. Setting L2 Unknown Unicast to HW Proxy ensures the spine/leaf fabric will proxy ARP and unknown-unicast MAC requests for those migrated servers so that "silent" hosts are reachable without flooding.



An EPG is associated with a VMM domain. Which option must be set to allow the bridge domain and the VRF of the EPG to be instantiated on all leaf switches that discovered the ESXi host?

  1. Immediate Resolution immediacy
  2. On-Demand Resolution immediacy
  3. On-Demand Deployment immediacy
  4. Immediate Deployment immediacy

Answer(s): C

Explanation:

Setting the EPG's Deployment immediacy to On-Demand ensures that the bridge domain and VRF are only pushed down to - and instantiated on - the leaf switches that actually see the ESXi host, rather than all leaves up front.



On which endpoint type is the host tracking feature performed in the Cisco ACI fabric?

  1. local endpoint
  2. bounce entry endpoint
  3. on-peer endpoint
  4. remote endpoint

Answer(s): D

Explanation:

The host-tracking feature in ACI issues ARP/ND probes only for remote endpoints (those learned via unicast routing), in order to verify ongoing reachability. It does not run against purely local, bounce, or on-peer endpoint types.



A Cisco ACI fabric has detected EP1 with IP address 192.168.1.1 to MAC M1 on interface Eth1/1. The fabric is designed so that when EP1 is down, a new EP2 receives the same IP address with a different MAC M2 on the same interface Eth1/1. Which two features must be enabled to meet this requirement? (Choose two.)

  1. ARP Flooding
  2. L3 Unknown Multicast Optimized Flood
  3. L2 Unknown Unicast Hardware Proxy
  4. GARP Based Detection
  5. EPG Flood in Encapsulation

Answer(s): A,D

Explanation:

ARP Flooding must be enabled on the Bridge Domain so that gratuitous ARPs from the replacement host actually flood through the fabric (otherwise the leafs' default proxy behavior would swallow them).
GARP-Based Detection uses those flooded gratuitous ARP frames to detect the IP/MAC change and promptly clear the old endpoint entry when the new host comes up on the same port.



Refer to the exhibit.



An engineer migrates a legacy data center to a new Cisco ACI fabric. The new deployment must raise a fault if a Layer 2 loop is detected from the external networking devices. Due to the large number of workloads still running on the legacy network, the interconnection links must not be disabled. The engineer has already enabled the MCP globally. Which configuration completes the configuration?

  1. Disable Loop Protection Action on MCP global policy.
  2. Enable MCP in the interconnection links.
  3. Configure MCP on all the legacy extended VLANs.
  4. Implement MCP PDU per VLAN on the legacy-facing interfaces.

Answer(s): D

Explanation:

By default, Mis-Cabling Protocol (MCP) BPDUs are only sent in the native VLAN. To detect loops in the other VLANs carried across your legacy trunk, you must enable per-VLAN MCP so that an MCP PDU is transmitted in each VLAN on those interfaces; this raises the loopdetection fault without disabling the ports.



Share your comments for Cisco 300-620 exam with other users:

T
test user
9/24/2023 3:15:00 AM

thanks for the questions

D
Draco
7/19/2023 5:34:00 AM

please reopen it now ..its really urgent

M
Megan
4/14/2023 5:08:00 PM

these practice exam questions were exactly what i needed. the variety of questions and the realistic exam-like environment they created helped me assess my strengths and weaknesses. i felt more confident and well-prepared on exam day, and i owe it to this exam dumps!

A
abdo casa
8/9/2023 6:10:00 PM

thank u it very instructuf

D
Danny
1/15/2024 9:10:00 AM

its helpful?

H
hanaa
10/3/2023 6:57:00 PM

is this dump still valid???

G
Georgio
1/19/2024 8:15:00 AM

question 205 answer is b

M
Matthew Dievendorf
5/30/2023 9:37:00 PM

question 39, should be answer b, directions stated is being sudneted from /21 to a /23. a /23 has 512 ips so 510 hosts. and can make 4 subnets out of the /21

A
Adhithya
8/11/2022 12:27:00 AM

beautiful test engine software and very helpful. questions are same as in the real exam. i passed my paper.

S
SuckerPumch88
4/25/2022 10:24:00 AM

the questions are exactly the same in real exam. just make sure not to answer all them correct or else they suspect you are cheating.

S
soheib
7/24/2023 7:05:00 PM

question: 78 the right answer i think is d not a

S
srija
8/14/2023 8:53:00 AM

very helpful

T
Thembelani
5/30/2023 2:17:00 AM

i am writing this exam tomorrow and have dumps

A
Anita
10/1/2023 4:11:00 PM

can i have the icdl excel exam

B
Ben
9/9/2023 7:35:00 AM

please upload it

A
anonymous
9/20/2023 11:27:00 PM

hye when will post again the past year question for this h13-311_v3 part since i have to for my test tommorow…thank you very much

R
Randall
9/28/2023 8:25:00 PM

on question 22, option b-once per session is also valid.

T
Tshegofatso
8/28/2023 11:51:00 AM

this website is very helpful

P
philly
9/18/2023 2:40:00 PM

its my first time exam

B
Beexam
9/4/2023 9:06:00 PM

correct answers are device configuration-enable the automatic installation of webview2 runtime. & policy management- prevent users from submitting feedback.

R
RAWI
7/9/2023 4:54:00 AM

is this dump still valid? today is 9-july-2023

A
Annie
6/7/2023 3:46:00 AM

i need this exam.. please upload these are really helpful

S
Shubhra Rathi
8/26/2023 1:08:00 PM

please upload the oracle 1z0-1059-22 dumps

S
Shiji
10/15/2023 1:34:00 PM

very good questions

R
Rita Rony
11/27/2023 1:36:00 PM

nice, first step to exams

A
Aloke Paul
9/11/2023 6:53:00 AM

is this valid for chfiv9 as well... as i am reker 3rd time...

C
Calbert Francis
1/15/2024 8:19:00 PM

great exam for people taking 220-1101

A
Ayushi Baria
11/7/2023 7:44:00 AM

this is very helpfull for me

A
alma
8/25/2023 1:20:00 PM

just started preparing for the exam

C
CW
7/10/2023 6:46:00 PM

these are the type of questions i need.

N
Nobody
8/30/2023 9:54:00 PM

does this actually work? are they the exam questions and answers word for word?

S
Salah
7/23/2023 9:46:00 AM

thanks for providing these questions

R
Ritu
9/15/2023 5:55:00 AM

interesting

R
Ron
5/30/2023 8:33:00 AM

these dumps are pretty good.

AI Tutor 👋 I’m here to help!