API API-936 Dumps PDF Free Download - Page: 5

QUESTION: 9

[Installation Procedures]
Who is responsible to approve refractory dryout procedures that have more than one heat source?

Contractor
Owner
Manufacturer
Inspector

Answer(s): B

Reveal Solution Next Question

QUESTION: 10

[Installation Procedures]
During gunning, inclusion of rebound is minimized by which of the following techniques?

Begin gunning at the lowest level and work around to full thickness in a spiral pattern
Start at the lowest level elevation and build up gradually to full thickness in complete rings
Start at the lowest level and build up gradually to full thickness in an area not more than 10 ft² (1 m²)
Cover all areas up to 1/2-in (13 mm) thick stud tip thickness before building to full thickness

Answer(s): C

Reveal Solution Next Question

[Inspection and Testing Requirements]
Which of the following is the appropriate term for testing refractory that was sampled during project site installation in order to confirm that it meets specified physical property standards?

Hammer testing
Pre-qualification testing
As-installed testing
Visual testing

Answer(s): C

Reveal Solution Next Question

QUESTION: 12

[Material Requirements]
The quantity of manufactured refractory that has the same formulation as that prepared in an uninterrupted manufacturing operation is called a:

pallet
test sample
production run
bag

Answer(s): C

Reveal Solution Next Question

QUESTION: 13

[Inspection and Testing Requirements]
Which of the following is a quality control element?
(This may have more than one correct answer; please select all answers that apply.)

As-installed testing
Initial Inspection
Installation monitoring
Report writing

Answer(s): A,B,C

Reveal Solution Next Question

QUESTION: 14

[Installation Procedures]
If the refractory lining is required before pressure testing, all pressure-retaining welds shall:

be lined with coal tar epoxy.
include additional anchors.
remain unlined and exposed to test medium.
be gunned with no needles.

Answer(s): C

Reveal Solution Next Question

QUESTION: 15

[Material Requirements]
When water is used for refractory installed on a carbon steel surface with a stainless steel anchorage, the chloride content of the potable water shall not exceed:

50 ppm
100 ppm
200 ppm
250 ppm

Answer(s): A

Reveal Solution Next Question

QUESTION: 16

[Inspection and Testing Requirements]
When performing the ASTM C704 and ASTM C133 refractory tests, the specimen should be fired to what temperature?

815°F (435°C)
1000°F (540°C)
1500°F (815°C)
2730°F (1500°C)

Answer(s): C

Reveal Solution Next Question

API Refractory Personnel API-936 Dumps in PDF

Free API API-936 Real Questions (page: 5)

QUESTION: 9

QUESTION: 10

QUESTION: 11

QUESTION: 12

QUESTION: 13

QUESTION: 14

QUESTION: 15

QUESTION: 16