Fortinet NSE7 Enterprise Firewall - FortiOS 5.4 (Replaced with NSE7_EFW-7.0) NSE7_EFW Dumps in PDF

Free Fortinet NSE7_EFW Real Questions (page: 3)

What is the diagnose test application ipsmenitor 5 command used for?

  1. To enable IPS bypass mode
  2. To disable the IPS engine
  3. To restart all IPS engines and monitors
  4. To provide information regarding IPS sessions

Answer(s): A

Explanation:

# diagnose test application ipsmonitor
5: Toggle bypass status
13: IPS session list
98: Stop all IPS engines
99: Restart all IPS engines and monitor



An administrator has configured two FortiGate devices for an HA cluster.
While testing HA failover, the administrator notices that some of the switches in the network continue to send traffic to the former primary device.
What can the administrator do to fix this problem?

  1. Configure remote link monitoring to detect an issue in the forwarding path.
  2. Configure set send-garp-on-failover enable under config system ha on both cluster members.
  3. Verify that the speed and duplex settings match between the FortiGate interfaces and the connected switch ports.
  4. Configure set link-failed-signal enable under config system ha on both cluster members.

Answer(s): D

Explanation:

Virtual MAC Address and Failover - The new primary broadcasts Gratuitous ARP packets to notify the network that each virtual MAC is now reachable through a different switch port. - Some high-end switches might not clear their MAC table correctly after a failover - Solution: Force former primary to shut down all its interfaces for one second when the failover happens (excluding heartbeat and reserved management interfaces): #Config system ha set link-failed-signal enable end - This simulates a link failure that clears the related entries from MAC table of the switches.



Which statement about IKE and IKE NAT-T is true?

  1. IKE is used to encapsulate ESP traffic in some situations, and IKE NAT-T is used only when the local FortiGate is using NAT on the IPsec interface.
  2. IKE is the standard implementation for IKEv1 and IKE NAT-T is an extension added in IKEv2.
  3. They both use UDP as their transport protocol and the port number is configurable.
  4. They each use their own IP protocol number.

Answer(s): C

Explanation:

IKE without NAT-T runs over UDP port 500. IKE with NAT-T runs over UDP port 4500. It can be configurable - https://docs.fortinet.com/document/fortigate/7.0.0/new- features/33578/configurable-ike-port



Refer to the exhibit, which contains the partial output of a diagnose command.



Based on the output, which two statements are correct? (Choose two.)

  1. The remote gateway has quick mode selectors containing a destination subnet of 10.1.2.0/24.
  2. The remote gateway IP is 10.200.5.1.
  3. DPD is disabled.
  4. Anti-replay is enabled.

Answer(s): A,D

Explanation:

Enterprise_Firewall_7.0_Study_Guide-Online.pdf p 427, 444 Since the local subnet is 10.1.2.0/24, the remote gateway has the destination subnet as 10.1.2.0. The remote gateway IP is 10.200.4.1. DPD is enabled (dpd-link=on)



Which statement about the designated router (DR) and backup designated router (BDR) in an OSPF multi-access network is true?

  1. Only the DR receives link state information from non-DR routers.
  2. Non-DR and non-BDR routers form full adjacencies to DR only.
  3. Non-DR and non-BDR routers send link state updates and acknowledgements to 224.0.0.6.
  4. FortiGate first checks the OSPF ID to elect a DR.

Answer(s): C

Explanation:

Some special IP multicast addresses are reserved for OSPF: 224.0.0.5: All OSPF routers must be able to transmit and listen to this address. 224.0.0.6: All DR and BDR routers must be able to transmit and listen to this address. https://www.cisco.com/c/en/us/support/docs/ip/open-shortest-path-first- ospf/7039-1.html



Share your comments for Fortinet NSE7_EFW exam with other users:

N
Naveed
8/28/2023 2:48:00 AM

good questions with simple explanation

C
cert
9/24/2023 4:53:00 PM

admin guide (windows) respond to malicious causality chains. when the cortex xdr agent identifies a remote network connection that attempts to perform malicious activity—such as encrypting endpoint files—the agent can automatically block the ip address to close all existing communication and block new connections from this ip address to the endpoint. when cortex xdrblocks an ip address per endpoint, that address remains blocked throughout all agent profiles and policies, including any host-firewall policy rules. you can view the list of all blocked ip addresses per endpoint from the action center, as well as unblock them to re-enable communication as appropriate. this module is supported with cortex xdr agent 7.3.0 and later. select the action mode to take when the cortex xdr agent detects remote malicious causality chains: enabled (default)—terminate connection and block ip address of the remote connection. disabled—do not block remote ip addresses. to allow specific and known s

Y
Yves
8/29/2023 8:46:00 PM

very inciting

M
Miguel
10/16/2023 11:18:00 AM

question 5, it seems a instead of d, because: - care plan = case - patient = person account - product = product2;

B
Byset
9/25/2023 12:49:00 AM

it look like real one

D
Debabrata Das
8/28/2023 8:42:00 AM

i am taking oracle fcc certification test next two days, pls share question dumps

N
nITA KALE
8/22/2023 1:57:00 AM

i need dumps

C
CV
9/9/2023 1:54:00 PM

its time to comptia sec+

S
SkepticReader
8/1/2023 8:51:00 AM

question 35 has an answer for a different question. i believe the answer is "a" because it shut off the firewall. "0" in registry data means that its false (aka off).

N
Nabin
10/16/2023 4:58:00 AM

helpful content

B
Blessious Phiri
8/15/2023 3:19:00 PM

oracle 19c is complex db

S
Sreenivas
10/24/2023 12:59:00 AM

helpful for practice

L
Liz
9/11/2022 11:27:00 PM

support team is fast and deeply knowledgeable. i appreciate that a lot.

N
Namrata
7/15/2023 2:22:00 AM

helpful questions

L
lipsa
11/8/2023 12:54:00 PM

thanks for question

E
Eli
6/18/2023 11:27:00 PM

the software is provided for free so this is a big change. all other sites are charging for that. also that fucking examtopic site that says free is not free at all. you are hit with a pay-wall.

O
open2exam
10/29/2023 1:14:00 PM

i need exam questions nca 6.5 any help please ?

G
Gerald
9/11/2023 12:22:00 PM

just took the comptia cybersecurity analyst (cysa+) - wished id seeing this before my exam

R
ryo
9/10/2023 2:27:00 PM

very helpful

J
Jamshed
6/20/2023 4:32:00 AM

i need this exam

R
Roberto Capra
6/14/2023 12:04:00 PM

nice questions... are these questions the same of the exam?

S
Synt
5/23/2023 9:33:00 PM

need to view

V
Vey
5/27/2023 12:06:00 AM

highly appreciate for your sharing.

T
Tshepang
8/18/2023 4:41:00 AM

kindly share this dump. thank you

J
Jay
9/26/2023 8:00:00 AM

link plz for download

L
Leo
10/30/2023 1:11:00 PM

data quality oecd

B
Blessious Phiri
8/13/2023 9:35:00 AM

rman is one good recovery technology

D
DiligentSam
9/30/2023 10:26:00 AM

need it thx

V
Vani
8/10/2023 8:11:00 PM

good questions

F
Fares
9/11/2023 5:00:00 AM

good one nice revision

L
Lingaraj
10/26/2023 1:27:00 AM

i love this thank you i need

M
Muhammad Rawish Siddiqui
12/5/2023 12:38:00 PM

question # 142: data governance is not one of the deliverables in the document and content management context diagram.

A
al
6/7/2023 10:25:00 AM

most answers not correct here

B
Bano
1/19/2024 2:29:00 AM

what % of questions do we get in the real exam?

AI Tutor 👋 I’m here to help!