351-001 Exam Questions and Answers | Exam-Dumps (Page: 2)

QUESTION: 6

Connecting an IS-IS router to four links and redistributing 75 routes from RIP. How many LSPs will be originated by this router?

One LSP: containing the router information, internal routes, and external routes
Six LSPs: one for each link, one containing router information, and one containing external routing information
Two LSPs: one containing router information and internal routes and one containing external routes
Three LSPs: one containing all links, one containing router information, and one containing external routing information

Answer(s): A

Reveal Solution Next Question

QUESTION: 7

According to the network in this exhibit, traffic directed towards 10.1.5.1 arrives at P4S-R4. Which path will the traffic take from here?

It will take P4S-R2.
It will not take any path. P4S-R4 will drop the traffic.
It will take P4S-R3.
It will load share between P4S-R2 and P4S-R3.

Answer(s): A

Reveal Solution Next Question

QUESTION: 8

You are the Cisco Network Designer in P4S. Which two characteristics are most typical of a SAN? (Choose two.)

NICs are used for network connectivity.
Servers request specific blocks of data.
Storage devices are directly connected to servers.
A fabric is used as the hardware for connecting servers to storage devices.

Answer(s): B,D

Reveal Solution Next Question

QUESTION: 9

The IGP next-hop reach ability for a BGP route is lost but a default route is available. Assuming that BGP connectivity is maintained, what will happen to the BGP route?

It will be put in a hold-down state by BGP until the next hop has been updated.
It will be removed from the BGP table.
It will be considered a valid route.
It will be considered invalid for traffic forwarding.

Answer(s): C

Reveal Solution Next Question

In the network presented in the following exhibit, all routers are configured to perform EIGRP on all interfaces. All interface bandwidths are set to 1000, and the delays are configured as displayed. In the topology table at Router P4S-RC, you see only one path towards 10.1.1.0/24. Why Router P4S-RC only has one path in its topology table?

Router P4S-RB is not advertising 10.1.1.0/24 to Router P4S-RC due to split horizon.
Router P4S-RD is not advertising 10.1.1.0/24 to Router P4S-RC because Router P4S-RC is its feasible successor.
Router P4S-RD is not advertising 10.1.1.0/24 to Router P4S-RC due to split horizon.
Router P4S-RB is not advertising 10.1.1.0/24 to Router P4S-RC because Router P4S-RC is its feasible successor.

Answer(s): C

Reveal Solution Next Question

Cisco 351-001 Exam (page: 2)
Cisco CCIE Routing and Switching v4.0 Written Beta
Updated on: 12-Feb-2026

QUESTION: 6

QUESTION: 7

QUESTION: 8

QUESTION: 9

QUESTION: 10

Cisco 351-001 Exam (page: 2) Cisco CCIE Routing and Switching v4.0 Written Beta Updated on: 12-Feb-2026

QUESTION: 6

QUESTION: 7

QUESTION: 8

QUESTION: 9

QUESTION: 10

Cisco 351-001 Exam (page: 2)
Cisco CCIE Routing and Switching v4.0 Written Beta
Updated on: 12-Feb-2026